This page covers 2 recalls and 82 owner complaints for the 2014 Yamaha Bolt.
The dominant pattern in 2014 Yamaha Bolt complaints centers on electrical system and instrument readability issues, with vehicle speed control rounding out the two most-reported areas. Owners frequently describe the instrument cluster display as extremely difficult or impossible to read in direct sunlight, with glare washing out the speedometer and all other displayed data. This makes checking speed while riding impractical under common daylight conditions. The speed control complaints largely tie back to the same readability problem, riders report being unable to confirm their speed because the display is unreadable rather than describing a mechanical throttle or cruise control failure. A smaller but recurring pattern involves steering instability reported at speeds roughly in the 35–45 mph range, with multiple owners describing a wobble or oscillation that unsettles the front end. Exterior lighting draws a handful of complaints as well, though at lower volume than the instrument and steering concerns.
82
Total Complaints
By System
The 2014 Yamaha Bolt has 2 recalls, both covering the same issue: a wiring harness routed too close to the exhaust that can melt and short circuit, blowing fuses and causing the engine to stall without warning while riding.
An unexpected stall raises the risk of a crash depending on speed, traffic, and road conditions at the time. Both recalls address this same defect and should be verified against the motorcycle's VIN to confirm which applies.
At a glance
What can fail
A wire harness routed too close to the rear exhaust can overheat and become damaged, potentially causing the engine to stall and power loss.
What the fix does
Dealers will install retaining bands to keep the wire harness away from the exhaust.
Summarized — see the official notice for exact wording, dates, and contacts.
We may earn a commission for purchases made through these links.
Complaints are owner-reported and reflect individual experiences, not confirmed defects. They are distinct from recalls. Data sourced from the national vehicle safety complaint database. See trending complaints →
At a glance
What can fail
The wiring harness may sag or hang loosely, allowing it to touch the hot exhaust manifold. This can melt the wires and cause electrical shorts.
What the fix does
Dealers will inspect the wiring harness and secure it away from the exhaust. Damaged harnesses will be replaced.
Summarized — see the official notice for exact wording, dates, and contacts.
