The 2008 Toyota Camry has 5 recalls, the most serious being three separate fire risks involving the power window master switch and, on vehicles with aftermarket heated seats, a seat heater element that can short circuit.
The power window master switch can overheat and melt due to inadequate lubrication inside the switch assembly, which can allow moisture and debris to cause a short circuit. This is a fire risk that starts at the driver's door control panel. The seat heater concern applies only to vehicles fitted with certain aftermarket heated seat accessories distributed through Southeast Toyota: if the copper heating element inside the seat cushion is damaged, it can short circuit and ignite surrounding material.
On the mechanical side, the accelerator pedal can become stiff, slow to return after you lift your foot, or in the most serious cases, stick in a partially pressed position, preventing the engine from dropping back to idle. A stuck accelerator in traffic or at highway speed makes it difficult to slow the vehicle and raises the risk of a crash.
The remaining recall involves a mislabeled tire and loading information sticker. If the label shows incorrect weight limits, owners relying on it could overload the vehicle or tires without realizing it, increasing the risk of tire failure.
At a glance
What can fail
The electrical wiring in aftermarket seat heaters with copper strand heating elements can be damaged when the seat cushion is compressed, potentially causing electrical issues.
What the fix does
Dealers will disconnect the seat heaters at no charge and refund the purchase price of the accessory.
Summarized — see the official notice for exact wording, dates, and contacts.
We may earn a commission for purchases made through these links.
At a glance
What can fail
The power window master switch may have inconsistent grease lubrication on its sliding electrical contacts, potentially causing the switch to malfunction.
What the fix does
Dealers will inspect the switch and apply lubricant if needed, or replace the circuit board if abnormalities are found.
Summarized — see the official notice for exact wording, dates, and contacts.
At a glance
What can fail
The weight capacity label on your vehicle is inaccurate by more than one percent, which means the stated weight limits don't match actual specifications required by federal safety standards.
What the fix does
Toyota will send you a corrected label with installation instructions. Some vehicles may need additional repairs being finalized. Contact Toyota at 1-800-301-6859.
Summarized — see the official notice for exact wording, dates, and contacts.
At a glance
What can fail
Power window master switches were lubricated using an imprecise process that created irregularities. These irregularities can cause the switches to malfunction and overheat.
What the fix does
Dealers will inspect the switch and apply special heat-inhibiting grease, or replace damaged switches at no cost to you.
Summarized — see the official notice for exact wording, dates, and contacts.
At a glance
What can fail
The friction lever inside the accelerator pedal sensor assembly can become smooth during normal use. When condensation forms on the worn surface—such as from using the heater without air conditioning on a cold pedal—friction increases. This can make the pedal harder to press, slower to return, or in severe cases, mechanically stuck in a partially depressed position.
What the fix does
Dealers will install a reinforcement bar in the accelerator pedal to restore smooth operation. This service is performed free of charge.
Summarized — see the official notice for exact wording, dates, and contacts.
