Ford Motor Company (Ford) is recalling certain 2018 Ford F-650 and F-750 trucks. The brake circuit hose assemblies located between the master cylinder and the hydraulic control unit, may have been manufactured without anti-corrosion plating on the coupling fittings, or "ferrules," of the hoses. This can lead to premature corrosion, and result in a brake fluid leak.
Safety Risk
A brake fluid leak can reduce brake effectiveness, increasing the risk of a crash.
Remedy
Ford will notify owners, and dealers will replace the brake hose assemblies, free of charge. The recall began on July 17, 2018. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 18S19.
1,474 vehicles affectedMfr ref: 18S19Updated June 10, 2026
THE SECONDARY HOOD LATCH MAY BE INCORRECTLY ALIGNED AND/OR MAY EXHIBIT A BINDING CONDITION AT THE LATCH PIVOT. EITHER OF THESE CONDITIONS COULD PREVENT ADEQUATE ENGAGEMENT OF THE SECONDARY HOOD LATCH. IN ADDITION, THE PRIMARY HOOD LATCH "POP-UP" LEVER MAY BE MISPOSITIONED AND COULD CAUSE THE HOOD TO APPEAR CLOSED WITHOUT BEING LATCHED. INADEQUATE ENGAGEMENT OF THE SECONDARY LATCH AND A MISPOSITIONED PRIMARY LATCH LEVER COULD RESULT IN HOOD FLY-UP WHEN THE VEHICLE IS IN MOTION.
Safety Risk
No risk description available.
Remedy
REPLACE SECONDARY HOOD LATCH, INSPECT PRIMARY HOOD LATCH, AND ALIGN OR REPLACE "POP-UP" LEVER.
18,068 vehicles affectedMfr ref: 6A22Updated June 10, 2026
THE ACCELERATOR PEDAL ASSEMBLY COULD BIND OR STICK DURING OPERATION.
Safety Risk
THIS CONDITION CAN CAUSE THE ACCELERATOR TO HOLD THE THROTTLE PARTIALLY OPEN, RESULTING IN LOSS OF VEHICLE CONTROL INCREASING THE RISK OF A VEHICLE ACCIDENT.
Remedy
DEALERS WILL REPLACE THE ACCELERATOR PEDAL ASSEMBLY.
On certain trucks, a problem in the engine control module (ECM) could cause a short circuit. If this happens, the engine could stall and you may not be able to restart it.
Safety Risk
A sudden loss of engine power could increase the risk of a crash.
Remedy
FCA Canada will notify owners by mail and instruct you to take your truck to a dealership to replace the engine control module.
420 vehicles affectedMfr ref: Z87Updated June 10, 2026
CERTAIN PICKUP TRUCKS EQUIPPED WITH BOTH VEHICLE STABILITY CONTROL (VSC) AND THE TRD DUAL EXHAUST SYSTEMS. THE TRD DUAL EXHAUST SYSTEM MET ALL CLEARANCE SPECIFICATIONS ON MODELS WITHOUT VSC, HOWEVER THE DRIVER'S SIDE EXHAUST LOCATED IN A POSITION WHERE CONTACT BETWEEN A BRAKE LINE FOUND ONLY ON VEHICLES WITH VSC AND THE TRD EXHAUST PIPE MIGHT OCCUR.
Safety Risk
IN THIS CONDITION, THE EXHAUST PIPE FLANGE MAY RUB AGAINST THE RIGHT REAR BRAKE LINE, WHICH COULD CAUSE BRAKE FLUID LEAKAGE. THIS COULD LEAD TO AN INCREASE OF VEHICLE STOPPING DISTANCE, WHICH COULD RESULT IN A CRASH.
Remedy
DEALERS WILL INSPECT AND, IF SO EQUIPPED, WILL REPLACE THE TRD DUAL EXHAUST SYSTEM FREE OF CHARGE. DURING THIS REPLACEMENT, THE DEALER WILL ALSO INSPECT THE SPECIFIC BRAKE LINE TO ASSURE IT HAS NOT BEEN DAMAGED AND REPLACE IT IF NECESSARY. THE RECALL BEGAN ON MAY 31, 2005. OWNERS SHOULD CONTACT TOYOTA AT 1-800-331-4331.
Volvo Trucks North America (Volvo Trucks) is recalling certain 2025 VN trucks. The tie rod assemblies may contain an improperly heat-treated ball stud that can fail, resulting in a sudden loss of steering control.
Safety Risk
A sudden loss of steering control increases the risk of a crash.
Remedy
Owners are advised not to drive their vehicles until the remedy has been completed. Dealers will inspect and replace the tie rod ends as necessary, free of charge. Owner notification letters were mailed June 18, 2024. Owners may contact Volvo Trucks customer service at 1-800-528-6586. Volvo Truck's number for this recall is RVXX2404.
3 vehicles affectedMfr ref: RVXX2404Updated June 10, 2026
Ford Motor Company (Ford) is recalling certain model year 2011-2014 Ford F-59 commercial chassis vehicles manufactured December 17, 2009, to April 30, 2014. Corrosive environments, such as water mixed with road salt, may cause a short circuit between the electrical junction block and the mounting bracket/frame.
Safety Risk
A short circuit may result in a fire.
Remedy
Ford will notify owners, and dealers will replace the junction block with an improved design, free of charge. The recall began on July 28, 2014. Owners may contact Ford customer service at 1-800-392-3673. Ford's number for this recall is 14S11. Note: Since the short may result in a fire whether the vehicle is being operated or not, owners are advised to park affected vehicles outside until they have received the recall remedy.
4,867 vehicles affectedMfr ref: 14S11Updated June 10, 2026
TRUCKS EQUIPPED WITH AIR BRAKES AND PRODUCED AT THE KENTUCKY TRUCK PLANT. SOME CAST ALUMINUM BRAKE PEDAL LEVERS MAY BE CRACKED. IF CRACKING IS PRESENT, A COMPLETE FRACTURE OF THE PEDAL LEVER MAY OCCUR DURING REPEATED BRAKING OR HIGH PEDAL LOADING. THIS CONDITION WOULD PREVENT APPLICATION OF THE SERVICE BRAKES ONLY.
Safety Risk
No risk description available.
Remedy
No remedy description available.
480 vehicles affectedMfr ref: 341Updated June 10, 2026
The rear brake control mounting bolts may not securely attach the rear brake control to the frame and could fail due to stress. Bolt failure will allow the rear brake control to disengage from the motorcycle without prior warning resulting in a loss of rear wheel brakinbg capability.
Safety Risk
No risk description available.
Remedy
No remedy description available.
436 vehicles affectedMfr ref: 50Updated June 10, 2026
On certain vehicles, a misrouted battery cable to the alternator could contact the metal tubing that is part of the power steering line. This could eventually wear the insulation and result in an electrical short. An electrical short could potentially result in a fire, or in a no-start or stall.
Safety Risk
No risk description available.
Remedy
Dealers will inspect vehicles and the battery cable will rerouted or replaced as required.
8,036 vehicles affectedMfr ref: 01S02Updated June 10, 2026
On certain vehicles, the fuel tank vent valve may not have been properly welded to the fuel tank. As a result, the vent valve could separate from the tank in a crash and create a fuel leak.
Note: This recall only affects gasoline-powered vehicles equipped with a 95 L fuel tank.
Safety Risk
A fuel leak can create the risk of a fire.
Remedy
Ford will notify owners by mail and instruct you to take your vehicle to a dealership to replace the fuel tank.
107 vehicles affectedMfr ref: 23S04Updated June 10, 2026
VEHICLE DESCRIPTION: PASSENGER VEHICLES. INADVERTENT DEPLOYMENT OF THE AIR BAGS CAN OCCUR DUE TO WATER INTRUSION.
Safety Risk
DEPLOYMENT OF THE AIR BAG WITHOUT WARNING COULD CAUSE A DRIVER TO LOSE VEHICLE CONTROL INCREASING THE RISK OF A VEHICLE CRASH AND PERSONAL INJURY.
Remedy
DEALERS WILL CLEAN THE EXTERIOR CASE OF THE SENSING AND DIAGNOSTIC MODULE (SDM) AND APPPLY A POTTING COMPOUND TO THE SDM CASE AND ELECTRICAL CONNECTOR BODY.
Ford Motor Company (Ford) is recalling certain model year 2005-2014 Mustang vehicles manufactured April 6, 2004, to June 21, 2014, and 2005-2006 GT vehicles manufactured February 20, 2004, to September 22, 2006. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture.
Safety Risk
In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death.
Remedy
Owners are advised not to drive their vehicles until the repair has been performed. Ford will notify owners, and dealers will replace the front driver side air bag inflator, free of charge. The recall began on June 10, 2016. Even if interim repairs were performed under safety recall 14V-802, owners must bring their vehicles in for the final remedy. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 15S21. Note: This recall supersedes safety recall 14V-802.
1,018,622 vehicles affectedMfr ref: 15S21Updated June 10, 2026
Ford Motor Company (Ford) is recalling certain model year 2005-2014 Mustang vehicles manufactured April 6, 2004, to June 21, 2014, and 2005-2006 GT vehicles manufactured February 20, 2004, to September 22, 2006. The affected vehicles are equipped with a dual-stage driver frontal air bag that may be susceptible to moisture intrusion which, over time, could cause the inflator to rupture.
Safety Risk
In the event of a crash necessitating deployment of the driver's frontal air bag, the inflator could rupture with metal fragments striking the driver or other occupants resulting in serious injury or death.
Remedy
Owners are advised not to drive their vehicles until the repair has been performed. Ford will notify owners, and dealers will replace the front driver side air bag inflator, free of charge. The recall began on June 10, 2016. Even if interim repairs were performed under safety recall 14V-802, owners must bring their vehicles in for the final remedy. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 15S21. Note: This recall supersedes safety recall 14V-802.
On certain motorcycles, the chain roll pin roller (between the fuel tank and the top chain run) could break. If fragments become lodged between the chain and pinion, it could cause the rear wheel to lock, which could result in a crash.
Safety Risk
No risk description available.
Remedy
Dealers will replace the bracket of the top chain take-up roller.
178 vehicles affectedMfr ref: MC10-04Updated June 10, 2026
On certain vehicles, the rubber section of the fuel lines could deteriorate and disconnect from the metal fittings, causing a fuel leak which may result in a fire in the engine compartment.
Safety Risk
No risk description available.
Remedy
Dealer will replace the fuel lines and attachments.
105 vehicles affectedMfr ref: 104Updated June 10, 2026
Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2013-2014 SFV650 and AN650A, and 2012-2014 DL650A motorcycles. Contamination from component production and storage combined with manufacturing variations may result in excessive tappet and camshaft wear within the engines of the affected motorcycles.
Safety Risk
The excessive wear may result in an engine stall, increasing the risk of a crash.
Remedy
Suzuki will notify owners, and dealers will inspect the tappet clearance, replacing the tappets and camshafts, as necessary. All motorcycles that have less than 2500 miles will have their tappets and camshafts replaced since wear may not be evident. These repairs will be performed free of charge. The recall began on February 5, 2016. Owners may contact Suzuki customer service at 1-714-996-7040. Suzuki's number for this recall is 2A50, 2A51, and 2A52.
6,214 vehicles affectedMfr ref: 2A50, 2A51, 2A52Updated June 10, 2026
Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2013-2014 SFV650 and AN650A, and 2012-2014 DL650A motorcycles. Contamination from component production and storage combined with manufacturing variations may result in excessive tappet and camshaft wear within the engines of the affected motorcycles.
Safety Risk
The excessive wear may result in an engine stall, increasing the risk of a crash.
Remedy
Suzuki will notify owners, and dealers will inspect the tappet clearance, replacing the tappets and camshafts, as necessary. All motorcycles that have less than 2500 miles will have their tappets and camshafts replaced since wear may not be evident. These repairs will be performed free of charge. The recall began on February 5, 2016. Owners may contact Suzuki customer service at 1-714-996-7040. Suzuki's number for this recall is 2A50, 2A51, and 2A52.
6,214 vehicles affectedMfr ref: 2A50, 2A51, 2A52Updated June 10, 2026
Suzuki Motor of America, Inc. (Suzuki) is recalling certain model year 2013-2014 SFV650 and AN650A, and 2012-2014 DL650A motorcycles. Contamination from component production and storage combined with manufacturing variations may result in excessive tappet and camshaft wear within the engines of the affected motorcycles.
Safety Risk
The excessive wear may result in an engine stall, increasing the risk of a crash.
Remedy
Suzuki will notify owners, and dealers will inspect the tappet clearance, replacing the tappets and camshafts, as necessary. All motorcycles that have less than 2500 miles will have their tappets and camshafts replaced since wear may not be evident. These repairs will be performed free of charge. The recall began on February 5, 2016. Owners may contact Suzuki customer service at 1-714-996-7040. Suzuki's number for this recall is 2A50, 2A51, and 2A52.
On certain vehicles equipped with a 6.7L diesel engine and a middle position fuel tank, there could be inadequate adhesion between the protective shield and the fuel conditioning module. This could allow for the the shield to be dislodged by road debris or water spray, which could force open the drain valve on the module. If the drain valve were to be forced open, this could result in substantial fuel leak. It could also allow for air ingress into the fuel system, which may cause the engine to stumble. A substantial fuel leak on a road surface could increase the risk of a crash, and a fuel leak in the presence of an ignition source could result in a fire causing injury and/or property damage.
Safety Risk
No risk description available.
Remedy
Dealers will replace the adhesive mounted protective shield on the fuel conditioning module with a bolt-on metallic protective shield.
12 vehicles affectedMfr ref: 16S39Updated June 10, 2026
