Daimler Vans USA, LLC (DVUSA) is recalling certain 2019 Mercedes-Benz Sprinter (Platform 907) vehicles equipped with high-beam assist. A software error in the control unit may prevent the driver from being able to switch off the high beams when intended.
Safety Risk
Being unable to turn off the high beams may result in oncoming traffic being blinded by the vehicle's lights, increasing the risk of crash.
Remedy
DVUSA will notify owners, and Mercedes-Benz or Freightliner Sprinter dealers will update the control unit software, free of charge. The recall began June 14, 2019. Owners may contact DVUSA customer service at 1-877-762-8267. DVUSA's number for this recall is VS3FERNLI.
HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTION, THE WIRES FOR THE LOWER BEAM CIRCUIT WERE PULLED TIGHTER THAN INTENDED. AFTER REPEATED USE OF THE HEADLIGHT SWITCH, THE ELECTRICAL CONNECTOR TERMINAL FOR THE LOW BEAM HEADLIGHT CIRCUIT CAN BECOME WORN AS A RESULT OF THIS TENSION, WHICH CAN RESULT IN LOW CONDUCTIVITY AND CAUSE AN ACCUMULATION OF COPPER OXIDE IN THE AREA OF THE CONTACTS.
Safety Risk
THE LOW BEAM HEADLIGHTS CAN BECOME INOPERATIVE DECREASING THE DRIVER'S VISIBILITY AS WELL AS THE VEHICLE'S VISIBILITY TO OTHER DRIVERS, INCREASING THE RISK OF A CRASH.
Remedy
DEALERS WILL INSPECT THE LOW BEAM TERMINAL AND PERFORM NECESSARY REPAIRS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 24, 2011. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.
A PLASTIC SLIDER PIECE WITHIN THE HEADLAMP DIMMER SWITCH ASSEMBLY DOES NOT FULLY RETRACT WHEN THE HEADLAMP DIMMER SWITCH IS MOVED FROM LOW BEAM TO HIGH BEAM POSITION. THE LOW BEAM LAMPS GO OUT AS INTENDED, BUT THE HIGH BEAM LAMPS DO NOT COME ON.
Safety Risk
THIS CONDITION WILL RESULT IN INADEQUATE LIGHTING CAUSING A VISIBILITY PROBLEM FOR THE DRIVER AND OTHER ONCOMING MOTORISTS AND AN ACCIDENT CAN OCCUR.
Remedy
DEALERS WILL REPLACE THE HEADLAMP DIMMER SWITCH ASSEMBLY.
