9,410 of 25,981 recalls from Transport Canada and NHTSA.
On certain vehicles, a transmission fluid pipe was not properly welded. As a result, the pipe may leak transmission fluid.
A transmission fluid leak on the roadway could create a hazard for others by making the road slippery.
Audi Canada will notify owners by mail and instruct you to take your vehicle to a dealer to inspect and replace the defective transmission fluid pipe, if necessary.
Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 126 - Electronic Stability Control Systems. Some brake actuator pumps may have been assembled with an O-ring that is damaged in such a way that the brake fluid pressure may not be properly controlled during Anti-Lock Braking (ABS), Traction Control (TRAC), and Vehicle Stability Control (VSC) system activation(s), which fails to meet the requirements of the standard. This could result in a loss of vehicle stability control, which could increase the risk of a crash causing injury and/or damage to property.
No risk description available.
Dealers will inspect the serial number of the brake actuator and, if necessary, replace the brake actuator assembly.
On certain vehicles, the fuel level sender may get stuck. If this happens, the fuel gauge can show a higher fuel level than what is actually in the fuel tank. This could cause a driver to believe there is fuel when the tank is empty. As a result, the vehicle could run out of fuel and stall.
A sudden loss of engine power could increase the risk of a crash.
Audi will notify owners by mail and instruct you to take your vehicle to a dealer to replace the fuel level sensor.
On certain motorcycles, the side-stand support tube may have an improper weld in the area that joins the support tube to the forged upper part of the side-stand. This could result in the side-stand breaking at that weld, which could cause the motorcycle to fall over, increasing the risk of injury to the rider and/or passenger.
No risk description available.
Dealers will inspect, and if necessary, replace the side-stand support tube with a new part.
Certain 1997-2001 Chevrolet Venture, Pontiac Montana/ Trans Sport, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors that were serviced in campaign 01013 (01v-067) from April to August 2001. Also 2001 Chevrolet Venture, Pontiac Montana, and Oldsmobile Silhouette mini vans equipped with passenger side power sliding doors assembled in January through April 2001. These vehicles have inadequate front welds. If a front weld fails, the actuator can jam in the unlatched position and, when the sliding door closes, it will not be latched. If this happens, the power sliding door can open while the vehicle is in motion, particularly when the vehicle ascends a hill, makes a turn, or travels over a rough road surface. An unrestrained occupant could fall out of the van and be injured.
No risk description available.
dealers will inspect the actuators for certain date codes and, if necessary, replace the actuators.
On certain motorcycles with Anti-Lock Brakes (ABS), there may be air within the brake system. This could cause a soft brake lever/pedal feel, and over time could lead to the a reduction in brake performance, increasing the risk of a crash causing injury and/or damage to property.
No risk description available.
Dealers will bleed the front and rear ABS brake system.
On certain motorcycles, the throttle cable guide was omitted during vehicle assembly. As a result, the throttle cables could become trapped in the steering stop, which could prevent the throttle from opening and closing normally. This could result in a loss of vehicle propulsion, or make it difficult to slow or stop the vehicle. Either issue could increase the risk of a crash causing property damage and/or personal injury.
No risk description available.
Dealers will install a throttle cable guide. Also, the throttle cables will be inspect and replaced if necessary.
On certain all-wheel drive vehicles, the fuel tank straps were improperly manufactured and could separate. This can cause the fuel tank to loosen and leak fuel. Fuel leakage, in the presence of an ignition source, can result in a fire.
No risk description available.
Dealers will replace the fuel tank retention straps.
Certain vehicles do not comply with labeling requirements of CMVSS120- Tire selection and rims for vehicles other than passenger cars.
No risk description available.
No remedy description available.
On certain motorcycles, the fuel tank valve assembly could become plugged. Under certain conditions this could cause the carburetor to overflow fuel which could result in a fire. This condition could also prevent sufficient fuel flow, which may cause the engine to misfire or stall. Either of these conditions could result in personal injury. In addition, certain M2 Cyclone models may have a component that could restrict airflow into the float bowl of the carburetor. This could cause the carburetor to overflow fuel which could result in a fire. This could also prevent sufficient fuel flow which may cause engine misfire or stalling.
No risk description available.
Fuel tank vent valve assembly will be replaced. M2 Cyclone models will have the float bowl assembly inspected for proper venting and have the condition corrected if necessary.
On certain vehicles equipped with the 6-speed Touchtronic II automatic transmission, the Engine Control Module software may not communicate correctly with the Transmission Control Module when the key is removed from the docking station. If this occurs, the transmission park pawl may not engage properly, which could result in unintended vehicle movement, increasing the risk of injury and/or property damage.
No risk description available.
Dealers will update the Transmission Control Module software.
THE FUEL TANK BREATHER VALVE MAY CAUSE BLOCKAGE OF THE FUEL TANK VENT SYSTEM. THIS CONDITION COULD CAUSE THE TANK TO DEFORM AND RUPTURE RESULTING IN GASOLINE LEAKAGE.
No risk description available.
No remedy description available.
On certain vehicles, if water enters the windshield wiper motor breather port, which is designed to allow the motor to vent warm air during normal operation, it can result in corrosion inside the motor housing. This could cause the windshield wiper motor to become inoperative, which could result in a vehicle crash causing personal injury or death.
No risk description available.
Dealers will affect repairs.
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 110 - Tire Selection and Rims. The Tire and Loading Information label may contain misspelled words in French.
No risk description available.
Owners will be supplied with a revised Tire and Loading Information Label and installation instructions. Owners may also have the label installed by a dealer.
On certain vehicles, the engine valve springs could break. As a result, the engine could fail and oil could leak onto hot components in the engine compartment.
An engine failure can cause a sudden loss of power to the wheels and could increase the risk of a crash. Additionally, oil that leaks onto hot components can create the risk of a fire.
Kia will notify owners by mail and advise you to take your vehicle to a dealership to replace the engine.
On certain vehicles, the rearview camera wiring harness could be damaged by movement and vibrations. If this happens, the rearview camera image may not display correctly or may not display at all. Canadian regulations require the rearview image to display when reversing.
A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash.
Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and secure the rearview camera wiring harness. The dealer will replace the rearview camera and wiring harness, if necessary.
Certain vehicles equipped with an anti-lock brake system (ABS) and without electronic stability control (ESC) may not comply with Canada Motor Vehicle Safety Standard (CMVSS) 105 - Hydraulic and Electric Brake Systems. The brake system indicator tell-tale may not illuminate during the lamp function check when the ignition is initially turned to the “ON” (run) position, which is contrary to the requirements of the standard.
No risk description available.
Dealers will correct the coding of the instrument cluster software.
On certain vehicles, the tow hitch cover on the rear bumper could detach while driving.
A tow hitch cover that detaches from the vehicle could create a road hazard for others and increase the risk of a crash.
Toyota will notify owners by mail and advise you to take your vehicle to a dealership to modify the rear bumper and replace the tow hitch cover.
On certain vehicles, a problem with the passenger occupant detection system can cause illumination of the airbag warning light and the airbag system may not properly classify the front passenger. In the event of a crash, the airbag system may not function properly, increasing the risk of injury to a front passenger.
No risk description available.
Dealers will install a passenger occupant detection system repair kit.
On certain vehicles, the connecting rod bearings may become damaged. If this happens, the engine could make abnormal noises and a warning light may turn on. If you continue to drive the vehicle with these symptoms, the engine could fail and/or an oil leak could occur.
An engine failure can cause a sudden loss of power, which could increase the risk of a crash. An oil leak could create the risk of a vehicle fire.
Volkswagen will notify owners by mail and instruct you to take your vehicle to a dealership for an engine inspection test. The engine will be replaced, if necessary.
We may earn a commission for purchases made through these links.
