152 of 25,867 recalls from Transport Canada and NHTSA.
On certain vehicles, the crankshaft position sensors may fail and cause an intermittent engine chuggle, stall or possible long starting crank time and/or a no-start condition, as well as illumination of the Malfunction Indicator Lamp (MIL).
No risk description available.
Dealers will replace both crankshaft position sensors.
Certain vehicles do not comply with CMVSS 1101 - emission device.
No risk description available.
No remedy description available.
NOTE: JEEP VEHICLES WITH 4.0 LITRE ENGINES, RENAULT VEHICLES WITH 2.0 LITRE ENGINES AND EAGLE PREMIER VEHICLES WITH 2.5 AND 3 LITRE ENGINES. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. FAULTY OXYGEN SENSOR COULD LEAD TO POOR FUEL/AIR CONTROL AND REDUCED CATALYST EFFICIENCY WHICH MAY INCREASE TAILPIPE EMISSIONS.
No risk description available.
OXYGEN SENSOR WILL BE REPLACED WITH ONE OF AN IMPROVED DESIGN.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1105 - EVAPORATIVE EMISSIONS. WRONG ROUTING OF PURGE HOSE.
No risk description available.
No remedy description available.
Certain G3 vehicles do not comply with CMVSS 1101 - Emission Device. Vehicle emission control information label missing
No risk description available.
Labels will be mailed to owners.
VEHICLES EQUIPPED WITH 3.0 LITRE ENGINES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS DUE TO LEAKING FUEL INJECTORS.
No risk description available.
INJECTORS WILL BE INSPECTED AND REPLACED WHERE NECESSARY.
Certain Volvo 242, 244 and 245 fail to comply with the requirements of CMVSS 1101 - Emission Devices
No risk description available.
No remedy description available.
Certain vehicles may not comply with CMVSS 1103 - exhaust emissions.
No risk description available.
Fuel injection pump boost control device and injection timing will be adjusted. New important engine information, engine calibration identification and autorized modifications labels will be attached to each truck serviced.
On certain C10 pickup trucks equipped with 454 cu. In. Engine. Engines have incorrect air injector pipe extensions so that the vehicle will not meet federal emission standards.
No risk description available.
No remedy description available.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. - MASS AIRFLOW SENSOR FAILURE - NOTE : VEHICLES WITH 3.0 LITRE AND 3.8 LITRE ENGINES.
No risk description available.
No remedy description available.
Certain vehicles equipped with a 360 cu. in., the engine were built with an incorrect distributor such that the vehicle will not comply with federal emission standards.
No risk description available.
No remedy description available.
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. EXHAUST MANIFOLD NUTS MAY BE SUSCEPTIBLE TO TORQUE RELAXATION RESULTING IN EXHAUST LEAKS FROM THE EXHAUST DOWNPIPE TO MANIFOLD JOINT.
No risk description available.
MANIFOLD NUTS WILL BE REPLACED WITH ONES OF A REVISED SPECIFICATION.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The Emission Maintenance Reminder (EMR) light in the climate control module is either non-functional (will not illuminate) due to missing power and ground circuits to the bulb or, is missing entirely.
No risk description available.
Jumper cables will be installed and the climate control module will be replaced where necessary.
VEHICLES WITH 3.0L ENGINES AND AUTOMATIC TRANSMISSIONS ONLY. THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S 1103 - EXHAUST EMISSIONS. CARBON MONOXIDE LEVELS EXCEED STANDARD.
No risk description available.
DEALERS WILL REPLACE THE ELECTRONIC ENGINE CONTROL (EEC) PROCESSOR AND ATTACH TWO DECALS.
THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1101 - EMISSION DEVICE.
No risk description available.
No remedy description available.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The calibration of the Powertrain Control Module (PCM) may fail to adequately control CO emissions.
No risk description available.
PCM will be reflashed with a new calibration.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S 1103 - EXHAUST EMISSIONS. CATALYSTS AND OXYGEN SENSORS MAY BE DEFECTIVE.
No risk description available.
CATALYTIC CONVERTER AND OXYGEN SENSOR WILL BE REPLACED WITH REDESIGNED COMPONENTS.
Certain vehicles may not comply with CMVSS 1103 - exhaust emissions. Improper calibration of the Powertrain Control Module may cause an increase in the levels of carbon monoxide (co) emissions to a level in excess of the Standard.
No risk description available.
Powertrain Control Module will be reprogrammed.
Certain vehicles may not comply with CMVSS1101 - Emission Device.
No risk description available.
No remedy description available.
NOTE: VEHICLES WITH 3.8 LITRE ENGINES. THESE VEHICLES MAY NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS. THE SUBSTRATE MATERIAL IN THE CATALYSTS MAY RATTLE AND BREAK UP DURING NORMAL USE CAUSING EXHAUST EMISSIONS TO EXCEED THE STANDARD.
No risk description available.
VEHICLES WILL BE INSPECTED AND CATALYST WILL BE REPLACED WHERE NECESSARY.
We may earn a commission for purchases made through these links.
