4,163 of 26,053 recalls from Transport Canada and NHTSA.
On certain B200 and B200T vehicles, the wiring insulation of the combination switch may wear off causing the rear or front wiper to malfunction. Improper operation of the wiper system in severe weather could reduce the driver's visibility, resulting in a vehicle crash.
No risk description available.
Dealers will replace the combination switch.
On certain vehicles, the instrument cluster could remain blank. As a result, warnings, tell-tales and gauges may not display. Note: This recall only affects vehicles equipped with a digital instrument cluster.
Warnings, tell-tales and gauges that don't display could increase the risk of a crash.
Ford will notify owners by mail and advise you to take your vehicle to a dealership to replace the instrument panel cluster or instrument panel cluster module, as necessary.
Ford Motor Company (Ford) is recalling certain 2021-2022 Bronco vehicles equipped with 8-inch SYNC infotainment screens that were previously repaired incorrectly under recall number 23V165. The rearview camera image may still be displayed after a backing event has ended. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
A rearview image that continues to be displayed after the vehicle is shifted out of reverse may distract the driver, increasing the risk of a crash.
Dealer will update the SYNC module software ,free of charge. Owner notification letters were mailed January 28, 2026. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25C72. Vehicle Identification Numbers (VINs) involved in this recall will be searchable on NHTSA.gov beginning January 30, 2026.
Ford Motor Company (Ford) is recalling certain 2023 Transit vehicles equipped with the Special Vehicle Operations Accessory Service Kit #1 or #2 with a High Specification Vehicle Interface Connector. When the accessory kit is installed, the auxiliary wire harness will disable the heating, air-conditioning, and ventilation (HVAC) including the defrost and defog systems. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 103, "Windshield Defrosting and Defogging Systems."
An inoperative windshield defrosting and defogging system may decrease the driver's visibility under certain driving conditions, increasing the risk of a crash.
Dealers will repair the auxiliary wire harness by modifying the wire harness to include the necessary twisted loop, free of charge. Owner notification letters were mailed April 20, 2023. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 23C02.
On certain motorcycles, the signal from the ignition lead of the secondary spark plug on the right hand cylinder could interfere with the oxygen sensor signal and cause the engine management control unit to reset. As a result, throttle response can be poor to the extent of engine misfire.
No risk description available.
Dealer will reroute the oxygen sensor cable.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain model year 2015 C300 and C400 vehicles manufactured from June 18, 2014, through September 5, 2014, that fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment." The affected vehicles were assembled with horizontal adjustment mechanisms that allow the owner to change the horizontal adjustment used during the manufacturing process, instead of the proper sealing caps.
If the original horizontal adjustment is used to alter the low beam aim, the misaimed headlamp may not properly illuminated the road or cause increased glare to oncoming drivers, which increases the risk of a crash.
Mercedes-Benz will notify owners, and dealers will replace the horizontal adjustment mechanisms on the headlamps with sealing caps on the affected vehicles. The recall began May 23, 2016. Owners may contact Mercedes at 1-800-367-6372.
Certain Ram 1500, 2500 and 3500 vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 101 - Controls and Displays. Some vehicles may experience loss of instrument cluster illumination and erratic functioning of certain cluster warning lights.
No risk description available.
Dealers will reprogram the instrument cluster module.
Kia Motors America (Kia) is recalling certain 2020-2021 Stinger vehicles. A software error in the instrument cluster may cause an inaccurate fuel gauge reading.
An inaccurate fuel gauge may result in the vehicle unexpectedly running out of fuel and stalling, increasing the risk of a crash.
Dealers will update the software, free of charge. Owner notification letters were mailed December 10, 2021. Owners may contact Kia customer service at 1-800-333-4542. Kia's number for this recall is SC219.
VOLVO IS RECALLING CERTAIN MODEL YEAR 2011-2013 S80 VEHICLES. A SOFTWARE ERROR MAY PREVENT THE TRANSMISSION FROM DOWNSHIFTING SUCH AS SHIFTING FROM FIFTH TO FOURTH GEAR WHEN COASTING.
THIS MAY RESULT IN DECREASED ENGINE RPMS AND POSSIBLE ENGINE STALL, INCREASING THE RISK OF A CRASH.
VOLVO WILL NOTIFY OWNERS, AND DEALERS WILL UPGRADE THE SOFTWARE TO THE TRANSMISSION CONTROL MODULE, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 10, 2012. OWNERS MAY CONTACT VOLVO CARS AT 1-800-458-1552.
General Motors LLC (GM) is recalling certain model year 2013 Chevrolet Sonic vehicles manufactured from May 29, 2012, through August 29, 2012. When a turn signal lamp fails to operate, the Body Control Module (BCM) in these vehicles does not detect this condition and will not indicate the condition to the driver. Thus, These vehicles fail to conform to Federal Motor Vehicle Safety Standard No. 108, "Lamps, Reflective Devices, and Associated Equipment."
If the driver is not aware that the turn signal is not functioning and does not have the light repaired, other drivers may not be alerted that the vehicle is turning, increasing the risk of a crash.
GM will notify owners, and dealers will reprogram the BCM and the vehicle's key fobs, free of charge. The safety recall began on October 3, 2012. Owners may contact the Chevrolet owner center at 1-866-694-6546.
SOUTHEAST TOYOTA IS RECALLING CERTAIN MODEL YEAR 2007-2011 TUNDRA VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 138, "TIRE PRESSURE MONITORING SYSTEMS." THE TPMS ON SOME VEHICLES MAY NOT HAVE BEEN PROPERLY CALIBRATED AND AS A RESULT THE LOW TIRE PRESSURE WARNING LAMP MAY NOT ILLUMINATE SHOULD THE INFLATION PRESSURE IN ONE OR MORE OF THE VEHICLE'S TIRES FALL BELOW THE THRESHOLD FOR WHEN THE LOW TIRE PRESSURE WARNING LAMP SHOULD ILLUMINATE.
DRIVERS WILL NOT RECEIVE A WARNING FROM THE TIRE PRESSURE MONITOR THAT ONE OR MORE TIRES ARE UNDERINFLATED, INCREASING THE RISK THAT THE VEHICLE WILL BE DRIVEN WITH ONE OR MORE UNDERINFLATED TIRES, INCREASING THE RISK OF A TIRE FAILURE THAT MAY LEAD TO A CRASH.
DEALERS WILL RECALIBRATE THE TIRE PRESSURE MONITORING SYSTEM IN ACCORDANCE WITH THE REGULATION FREE OF CHARGE. THE SAFETY RECALL BEGAN DURING JULY 2011. OWNERS MAY CONTACT SOUTHEAST TOYOTA CUSTOMER ASSISTANCE CENTER TOLL FREE AT 1-800-301-6859, MONDAY THROUGH FRIDAY, 8:30 AM TO 5:00 PM, EASTERN STANDARD TIME.
On certain motorcycles, the wiring for the hazard warning lamps may become damaged during normal steering. This could cause the hazard lamps to not function, which would result in not being able to clearly signal a stopped, disabled or slowly moving vehicle, increasing the risk of a crash causing injury and/or damage to property.
No risk description available.
Dealers will extend the wiring length by installing a replacement electrical block connector and fly lead onto the right-hand switch cube sub-harness.
Unruh Fire, Inc. (Unruh Fire) is recalling one 2018 Dodge 5500-based fire truck equipped with Whelen brake lights. Depending on the specific wiring of the vehicle, these brake lights may illuminate when the brake pedal has not been pressed.
If the brake lights incorrectly illuminate, it can confuse other drivers, possibly increasing the risk of a crash.
Unruh Fire has notified the owner and will provide replacement brake lights, free of charge. The recall began May 20, 2019. Owners may contact Unruh Fire customer service at 1-800-856-7080.
NISSAN IS RECALLING CERTAIN MODEL YEAR 2005-2009 TITAN, ARMADA, AND INFINITI QX56 VEHICLES. THE INSTRUMENT PANEL FUEL GAUGE MAY INACCURATELY DISPLAY THAT THE VEHICLE STILL HAS SOME FUEL, TYPICALLY ABOUT ONE QUARTER TANK, WHEN THE FUEL TANK IS EMPTY.
THIS COULD CAUSE THE VEHICLE TO RUN OUT OF GAS AND STALL ON THE HIGHWAY, WHICH COULD CAUSE A CRASH.
DEALERS WILL REPLACE THE FUEL SENDER UNIT INSIDE THE FUEL TANK WITH A NEW IMPROVED SENDER CARD. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 22, 2010. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
THESE VEHICLES DO NOT MEET THE ILLUMINATION REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
FOLLOWING VEHICLES MAY NOT BE AWARE THAT THE VEHICLE IN FRONT IS STOPPING, INCREASING THE RISK OF A VEHICLE CRASH.
OWNERS WILL BE PROVIDED WITH TWO NEW LIGHT BULBS FOR THE STOP/TAIL LAMPS WHICH ARE BRIGHTER THAN THE ORIGINAL BULBS. A LABEL WITH THE NEW BULB NUMBER WILL ALSO BE PROVIDED FOR INSERTION INTO THE OWNER'S MANUAL. IF AN OWNER SO DESIRES, A DEALERS CAN INSTALL THE LIGHT BULBS FOR THEM.
On certain vehicles, a software problem could cause the rearview camera image not to display properly. Canadian regulations require the rearview image to display when the transmission is shifted into reverse gear.
A rearview camera image that doesn't display properly could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash.
Aston Martin will notify owners by mail and send a wireless over-the-air software update to eligible vehicles to update the head unit software. Alternatively, you may schedule an appointment to have the update performed at an Aston Martin dealership.
Ford Motor Company (Ford) is recalling certain 2022 Transit vehicles. The rearview camera supplied in the Rear Video Camera and Prep Kit will not function when installed by the final stage manufacturer (upfitter), resulting in a blank rearview image.
A camera that does not display a rearview image while reversing can reduce the driver's view of what is behind the vehicle, increasing the risk of a crash.
Dealers will update the audio control module configuration settings, free of charge. Owner notification letters were mailed on April 12, 2022. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 22S18.
Ford Motor Company (Ford) is recalling certain 2019 Ranger trucks. The inline electrical connector terminals for the rear lights may be misaligned or not properly seated, potentially causing the rear lights to function intermittently or not at all.
Intermittent or inoperative tail lamps can result in loss of stop, turn, rear position, and reverse lamp functions, which reduces the vehicle's visibility and may not fully alert other drivers that the vehicle is braking, turning, or reversing, increasing the risk of crash.
Ford will notify owners, and dealers will inspect the inline connector for loose terminals and replace the connectors, if necessary, free of charge. The recall began March 5, 2020. A renotification was sent on July 10, 2020. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 19S43.
On certain vehicles, the stop lamp switch may have been contaminated with silicone grease during vehicle assembly. This could prevent proper brake lamp operation. Failure of the brake lamps to illuminate when the brakes are applied may result in the following road users being unaware of the driver's intentions, increasing the risk of a crash causing injury or death.
No risk description available.
Dealers will replace the stop lamp switch.
On certain vehicles, the air bag control unit may not work properly due to a software error. As a result, the airbag warning light and warning messages may not turn on when there is a problem with the airbag system or the pedestrian protection system.
An airbag system that does not work properly could increase the risk of injury in a crash.
BMW will notify owners by mail and instruct you to take your vehicle to a dealership to update the airbag control unit software. To reduce the safety risk, BMW recommends that you should not transport any passengers until the recall repairs have been completed.
We may earn a commission for purchases made through these links.
