The 2006 BMW HP2 Enduro has 3 recalls, the most serious involving two separate crash risks: a front suspension fastener that can work loose and separate, and a rear wheel mounting flange that can crack and allow the rear wheel to detach.
The suspension fastener connects the Paralever link at the front and, if it loosens over time, can compromise handling to the point of causing a crash. The rear wheel issue stems from a cracked mounting flange that lets the wheel bolts loosen, leaving the wheel unsecured and the motorcycle unstable. There is also a fuel system concern affecting bikes that were previously repaired under an earlier recall using a support ring fix but never had the fuel pump replaced: the pump can leak fuel, and if that fuel contacts an ignition source, it raises the risk of fire.
At a glance
What can fail
The fuel pump flange can crack, causing fuel to leak while the engine runs. This applies to certain motorcycles previously repaired under recall 13V-617 where the fuel pump was not replaced.
What the fix does
Dealers will replace the fuel pump(s) with an improved version at no cost.
Summarized — see the official notice for exact wording, dates, and contacts.
We may earn a commission for purchases made through these links.
At a glance
What can fail
The aluminum rear wheel mounting flange can crack if the bolts are over-tightened during installation or maintenance.
What the fix does
Dealers will replace the aluminum rear wheel flange with a steel one at no cost.
Summarized — see the official notice for exact wording, dates, and contacts.
At a glance
What can fail
A front fastener on the Paralever link may loosen and separate due to build tolerances and insufficient torque, compromising motorcycle handling.
What the fix does
Dealers will replace the fastener with an improved version.
Summarized — see the official notice for exact wording, dates, and contacts.
