On certain vehicles, the cable that controls the recliner mechanisms of the left side fold flat second row seat may have been misadjusted, which could prevent it from latching correctly. In the event of a crash, a partially latched recliner seat back could move forward, increasing the risk of injury to the seat occupants.
Safety Risk
No risk description available.
Remedy
Service Center will readjust the left side fold flat second row seat cable.
413 vehicles affectedMfr ref: SB-17-13-004Updated June 10, 2026
On certain vehicles, during fast-charging or preparation for fast-charging, the infotainment central processing unit (CPU) may overheat. This could cause the CPU to be slow or to restart. As a result, the center screen display may lag or appear blank. If this happens, the rearview camera display, windshield wiper and defroster settings, drive modes (i.e., Drive, Neutral, or Reverse), and telltales may not be available.
Safety Risk
A driver who does not have access to vehicle systems and controls could have an increased risk of a crash.
Remedy
Tesla will email a notice to owners and provide an over-the-air firmware update to fix this problem.
11,636 vehicles affectedMfr ref: SB-22-00-009Updated June 10, 2026
On certain P3 vehicles with i-beam front suspensions and automatic transmissions, the shift lever may not drop into the "park" detent when placed into the "park" position. This would allow the shift lever to move from "park" to "reverse" without the operator having to lift the shift lever and could result in the transmission being placed in reverse gear unintentionally. This could cause a vehicle crash without prior warning.
Safety Risk
No risk description available.
Remedy
Vehicles will be inspected and shift linkage and steering column will be adjusted if necessary. If adjustment is ineffective, the upper steering column bracket will be replaced.
42 vehicles affectedMfr ref: 9A19/89029Updated June 10, 2026
THESE VEHICLES MAY CONTAIN FRONT SUSPENSION CAM BOLTS WHICH MAY FAIL DUE TO ASSEMBLY MISALIGNMENT WHICH COUULD CAUSE THE BOLT TO BEND AND POSSIBLY CRACK DURING INSTALLATION. FAILURE OF THE BOLT MAY CAUSE THE VEHICLE TO PULL TO ONE SIDE WHEN THE BRAKES ARE APPLIED. THIS COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.
Safety Risk
No risk description available.
Remedy
FRONT SUSPENSION CAM BOLTS, CAM WASHERS AND NUTS WILL BE REPLACED WITH COMPONENTS OF A DIFFERENT DESIGN.
2,073 vehicles affectedMfr ref: 563Updated June 10, 2026
On certain 2wd vehicles, the front hubs may have been manufactured incorrectly and could crack. This could allow the wheel to wobble, causing a noticeable vibration and, as a result, the driver may experience difficulty controlling the direction of the vehicle. Ultimately, the hub may break, allowing the wheel to separate from the vehicle. The errant wheel assembly could strike a vehicle, a stationary object, or a bystander. These issues could result in property damage and/or personal injury.
Safety Risk
No risk description available.
Remedy
Dealers will replace both front wheel hub assemblies.
13 vehicles affectedMfr ref: PC188Updated June 10, 2026
Certain vehicles equipped with rearward folding head restraints on the second row seats. Two potential pinch points exist on each of the folding head restraints when the head restraint(s) are folded rearward as the seatback is folded down. If a person were to insert their finger(s) into the pinch point when the head restraint folds, it could trap and pinch the finger(s) causing injury.
Safety Risk
No risk description available.
Remedy
Dealers will install protective covers over the pinch points.
17,569 vehicles affectedMfr ref: 02039Updated June 10, 2026
VEHICLES EQUIPPED WITH SIX CYLINDER ENGINES AND AUTOMATIC TRANSMISSIONS MAY HAVE IMPROPERLY INSTALLED TRANSMISSION THROTTLE CONTROL ROD SPRINGS THAT COULD AFFECT THE THROTTLE CLOSURE RATE, WHICH COULD AFFECT THE VEHICLE BRAKING DISTANCE.
Safety Risk
No risk description available.
Remedy
No remedy description available.
99 vehicles affectedMfr ref: TSPRINGUpdated June 10, 2026
On certain trucks, the windshield wiper arms may not have been manufactured correctly. As a result, the wiper arms could slip and they may not wipe the windshield properly.
Safety Risk
Windshield wipers that do not work properly could affect a driver's visibility. This could increase the risk of a crash.
Remedy
Ford will notify owners by mail and instruct you to take your vehicle to a dealership to replace the windshield wiper arms.
77,815 vehicles affectedMfr ref: 22S26Updated June 10, 2026
On certain vehicles, the piston oil rings may not have been manufactured properly and could damage the cylinder walls. As a result, the engine could make abnormal noises, and a warning light may turn on. If you continue to drive the vehicle with these symptoms, the engine could fail.
Note: This recall only affects certain vehicles equipped with a 2.0L MPI engine.
Safety Risk
An engine failure could cause a sudden loss of power to the wheels and/or increase the risk of a vehicle fire. Both issues could increase the risk of a crash or injury.
Remedy
Kia will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the engine. The dealer will also install a software that will monitor the engine and warn you if it detects a problem. If you see this warning, you should contact a dealership to arrange replacement of the engine.
25,279 vehicles affectedMfr ref: RC215Updated June 10, 2026
On certain vehicles, the frame down tube may crack below the steering head gusset under certain conditions. Continued use could cause the rider to lose control of the motorcycle resulting in a possible crash.
Safety Risk
No risk description available.
Remedy
Vehicles will be inspected and, if required, gussets will be welded to the frame tubes or the frame will be replaced.
359 vehicles affectedMfr ref: MC-00-10Updated June 10, 2026
On certain motorcycles, the fuel tank can crack at the mounting tabs, allowing fuel to leak from the tank. Fuel leakage, in the presence of an ignition source, could result in a fire.
Safety Risk
No risk description available.
Remedy
Dealers will inspect and, if necessary, replace the fuel tank. Tank mounting dampers will also be installed.
440 vehicles affectedMfr ref: MC07-04Updated June 10, 2026
THE FUEL AND REAR BRAKE TUBES MAY EXPERIENCE ACCELERATED CORROSION BETWEEN THE TUBES AND A RUBBER ISOLATOR. FAILURE OF THESE TUBES COULD RESULT IN FUEL LEAKAGE AND/OR DIMINISHED BRAKING CAPACITY.
Safety Risk
No risk description available.
Remedy
BRAKE, FUEL SUPPLY AND FUEL VAPOUR TUBES WILL BE INSPECTED FOR THE PRESENCE OF RED CORROSION. ANY TUBES SHOWING EVIDENCE OF RED CORROSION WILL BE REPLACED. IN ADDITION VEHICLES WILL HAVE THE RUBBER ISOLATOR REPLACED WITH A PLASTIC CLIP.
33,158 vehicles affectedMfr ref: 705Updated June 10, 2026
On certain vehicles, the braking system could leak brake fluid. If this happens, there could be a partial or total loss of braking.
Safety Risk
Reduced braking or a loss of brakes can increase the risk of a crash.
Remedy
Ferrari will notify owners by mail. The corrective actions for this recall are under development and Ferrari will send you a second notice once a final repair is available. Ferrari advises that if the "Low Brake Fluid" warning message appears on the vehicle dashboard, you should pull off the road as soon as it is safe to do so. You should then contact Ferrari Roadside Assistance and get towed to the nearest dealer.
1,088 vehicles affectedMfr ref: 78Updated June 10, 2026
On certain vehicles, the recall repairs completed by a BMW dealer during recall 12 83 24RC (Transport Canada recall no. 2024-444) may not be effective. As a result, certain vehicles require a second repair.
On certain vehicles, if you try to start the engine repeatedly, the starter could overheat. If this happens, and nearby components contact the starter, it could cause a fire.
Safety Risk
A fire can create the risk of injury.
Remedy
BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the engine starter.
14,573 vehicles affectedMfr ref: 12 90 25RCUpdated June 10, 2026
AUTOMATIC FRONT WHEEL BEARING ADJUSTING NUTS MAY BE SUSCEPTIBLE TO DAMAGE DURING INSTALLATION OR REMOVAL DUE TO INCORRECT TOOLS OR INCORRECT TORQUE. ALSO, SOME OF THE NUTS MAY HAVE BEEN DAMAGED DURING VEHICLE ASSEMBLY. THIS CAN RESULT IN THE NUT HAVING THE POTENTIAL TO ROTATE FREELY AND LOOSE TORQUE. IN TURN THIS CONDITION COULD RESULT IN FRONT WHEEL SEPARATION.
Safety Risk
No risk description available.
Remedy
FRONT WHEEL BEARING ADJUSTING NUTS WILL BE REPLACED WITH CASTLE NUTS AND COTTER PINS.
30 vehicles affectedMfr ref: 98S05Updated June 10, 2026
On certain motorcycles, the front brake master cylinder may have a defective hydraulic circuit allowing air to be introduced into the brake system. This could result in degraded front brake performance, which would increase stopping distances, increasing the risk of a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will replace the front master cylinder pushrod and boot assembly.
484 vehicles affectedMfr ref: PA2ZZQ1602Updated June 10, 2026
TWO ENGINE MOUNTED THROTTLE RETURN SPRINGS ARE COVERED WITH DAMPING RUBBER SLEEVES THAT PREVENT SPRING OSCILLATION. IN HOT WEATHER CONDITIONS THE SLEEVES MAY SHRINK IN DIAMETER AND PREVENT THE RETURN SPRINGS FROM FULLY RETURNING THE THROTTLE TO THE IDLE POSITION UPON RELEASE OF THE ACCELERATOR PEDAL.
1977-1979 BMW 320I - 5420001 TO 5431989, 5435001 TO 5460000, 5470001 TO 5473695, 5475001 TO 5483070, 5490001 TO 5490886
Safety Risk
No risk description available.
Remedy
No remedy description available.
3,656 vehicles affectedMfr ref: 80V/076Updated June 10, 2026
On certain motorcycles, the rear brake clevis pin clip may rotate while engaging the rear brake, preventing the pedal to fully return to the original rest position. The rear brake could drag, creating excessive heat or premature brake pad wear, increasing the risk of a crash.
Safety Risk
No risk description available.
Remedy
Dealer will replace the rear brake retaining clip.
44 vehicles affectedMfr ref: 328Updated June 10, 2026
On certain model 2500/3500 HD vehicles, power steering hose clamps may not have been properly attached. This could allow the hose to disconnect from the power steering pump or steering gear, causing a power steering fluid leak. This would result in a loss of power steering assist and hydraulic assist brakes, unexpectedly increasing steering and brake pedal effort and potentially increasing stopping distances and the risk of a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will inspect the clamps to ensure they are properly attached.
8,778 vehicles affectedMfr ref: 14356Updated June 10, 2026
On certain motorcycles, an electrical connection can be created via the brake line between the anti-lock brake (ABS) modulator and vehicle ground. If the wiring harness is frayed and contacts the ABS modulator, there is a potential for the brake line to conduct electricity, causing overheating and ultimately melting the brake line. This can result in failure of the brake system circuit, increasing the risk of a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will inspect the wiring harness and re-position the wiring harness for the engine control unit. Additionally, dealers will add and attach a ground cable to the ABS modulator and mount it to the motorcycle’s frame.
359 vehicles affectedMfr ref: TB 1707Updated June 10, 2026
