12,493 of 25,892 recalls from Transport Canada and NHTSA.
Certain vehicles equipped with the 3.6L engine may experience an engine stall due to a loss of crankshaft position sensor synchronization. This could result in a loss of motive power, increasing the risk of a crash causing injury and/or damage to property.
No risk description available.
Dealers will update the engine control software.
Subaru of America, Inc. (Subaru) is recalling certain 2021 Impreza vehicles. The left-front lower control arm weld may fail, allowing the control arm to separate from the crossmember.
A separated control arm may cause the tire to contact the wheel well, resulting in a loss of control and increasing the risk of a crash.
Owners are advised not to drive their vehicle until the repair is complete. Dealers will inspect and replace the control arm as necessary, free of charge. Owner notification letters were mailed September 3, 2021. Owners may contact Subaru customer service at 1-844-373-6614. Subaru's number for this recall is WRI-21.
On certain vehicles, the housing of the driver's frontal airbag inflator may have been incorrectly welded during manufacturing and could separate from the base plate during an airbag deployment. If the vehicle were involved in a collision that warrants airbag deployment, metal fragments could be propelled toward vehicle occupants, which could increase the risk of injury.
No risk description available.
Dealers will replace the driver's frontal airbag.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2024 GLE350, GLE450, AMG GLE53, and AMG GLE53 Coupe vehicles. The accelerator pedal module bracket may have been improperly welded, which can result in the bracket breaking or detaching.
A broken or detached accelerator pedal can increase the risk of a crash or injury.
Dealers will drill through the spot welds and secure the bracket with rivets, free of charge. Owner notification letters were mailed April 5, 2024. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2024030009.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2024 GLE350, GLE450, AMG GLE53, and AMG GLE53 Coupe vehicles. The accelerator pedal module bracket may have been improperly welded, which can result in the bracket breaking or detaching.
A broken or detached accelerator pedal can increase the risk of a crash or injury.
Dealers will drill through the spot welds and secure the bracket with rivets, free of charge. Owner notification letters were mailed April 5, 2024. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2024030009.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2024 GLE350, GLE450, AMG GLE53, and AMG GLE53 Coupe vehicles. The accelerator pedal module bracket may have been improperly welded, which can result in the bracket breaking or detaching.
A broken or detached accelerator pedal can increase the risk of a crash or injury.
Dealers will drill through the spot welds and secure the bracket with rivets, free of charge. Owner notification letters were mailed April 5, 2024. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2024030009.
MAZDA IS RECALLING CERTAIN MODEL YEAR 2009-2010 MAZDA6 VEHICLES MANUFACTURED FROM APRIL 8, 2008, THROUGH FEBRUARY 8, 2010. A CERTAIN TYPE OF SPIDER MAY WEAVE A WEB IN THE EVAPORATIVE CANISTER VENT LINE AND THIS MAY CAUSE A RESTRICTION IN THE LINE. IF THIS OCCURS, THE FUEL TANK PRESSURE MAY BECOME EXCESSIVELY NEGATIVE WHEN THE EMISSION CONTROL SYSTEM WORKS TO PURGE THE VAPORS FROM THE CANISTER.
AS THE CANISTER IS PURGED REPEATEDLY DURING NORMAL OPERATION, THE STRESS ON THE FUEL TANK MAY EVENTUALLY RESULT IN A CRACK, POTENTIALLY LEADING TO FUEL LEAKAGE AD AN INCREASED RISK OF FIRE.
DEALERS WILL INSPECT AND CLEAN UP THE CANISTER VENT LINE, AND INSTALL A SPRING TO PREVENT THIS TYPE OF SPIDER FROM ENTERING THE VENT LINE. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE MARCH 25, 2011. OWNERS MAY CONTACT MAZDA CUSTOMER ASSISTANCE CENTER AT 1-800-222-5500.
THE SECONDARY HOOD LATCH MAY CONTACT THE SUPPORT BRACKET WHICH COULD PREVENT PROPER ENGAGEMENT OF THE SECONDARY LATCH. ADDITIONALLY, THE SECONDARY LATCH CAN CONTACT THE PRIMARY LATCH RETURN SPRING PREDISPOSING IT TO DISENGAGE.
No risk description available.
DEALER WILL INSTALL SKID PLATES ON ALL MODELS AND THE BERETTA MODELS WILL HAVE THE SECONDARY HOOD LATCH REPLACED.
On certain Wrangler 4xe plug-in hybrid electric vehicles (PHEV), the wrong bolt may have been used to connect the high-voltage battery fuse. As a result, the fuse could overheat and fail. If this happens, there could be a loss of power to the wheels.
A sudden loss of power to the wheels could increase the risk of a crash.
FCA Canada will notify owners by mail and advise you to take your vehicle to a dealership to inspect the 200 A fuse assembly in the high-voltage battery. If necessary, the dealer will replace the fuse assembly or the high-voltage battery pack.
General Motors LLC (GM) is recalling certain model year 2013-2014 Cadillac CTS, Escalade, Escalade ESV, Chevrolet Suburban, Tahoe, GMC Yukon, and Yukon XL, and 2014 Buick Enclave, Chevrolet Express, Impala, Silverado HD, Traverse, GMC Acadia, Savana, and Sierra HD vehicles. In the affected vehicles, the chassis electronic module may be internally contaminated, resulting in an electrical short.
If the module experiences an electrical short, the vehicle could stall, increasing the risk of a crash.
GM will notify owners, and dealers will replace the chassis electronic module, free of charge. The recall began on December 26, 2014. Owners may contact GM customer service at 1-800-521-7300 (Buick), 1-800-458-006 (Cadillac), 1-800-222-1020 (Chevrolet), and 1-800-462-8782 (GMC). GMs number for this recall is 14515.
ON CERTAIN MY 1996-1998 PASSENGER VEHICLES BUILT AT THE KANSAS CITY, CUAUTITLAN ASSEMBLY PLANTS OR ON MY 1999 PASSENGER VEHCLES BUILT AT THE AUTOMOTIVE ALLIANCE INTERNATIONAL ASSEMBLY PLANTS, THE ROUGH SURFACE OF THE HEATER BLOWER RESISTOR'S STAINLESS STEEL BLADES CAN DAMAGE THE COPPER SURFACE OF THE WIRING HARNESS CONNECTOR. THE DAMAGE COULD, OVER TIME, CAUSE INCREASED RESISTANCE IN THE CONNECTOR AND, DUE TO SUBSEQUENT TERMINAL RELAXATION, RESULT IN AN OPEN CIRCUIT CONDITION.
THE OPEN CIRCUIT COULD LEAD TO ELECTRICAL ARCING THAT COULD MELT THE CONNECTOR HOUSING MATERIAL CREASING THE POTENTIAL FOR A FIRE.
DEALERS WILL INSTALL A NEW HEATER BLOWER RESISTOR AND A NEW WIRE JUMPER HARNESS. OWNER NOTIFICATION BEGAN AUGUST 29, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-800-392-3673.
On certain motorcycles, the fuel tank breather valve may have been omitted during assembly. Under certain riding conditions, this could result in fuel to escape from the fuel tank breather assembly. Leaking fuel in the presence of an ignition source, could result in a fire causing injury and/or damage to property.
No risk description available.
Dealers will install a fuel tank breather valve and reroute the vent hose.
Certain motorcycles were built with a rear shock absorber that could break which could cause the underside of the vehicle to drag on the ground. This could adversely affect handling and result in a crash without prior warning.
No risk description available.
Dealers will install a shock reinforcement kit.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2021-2022 GLE350 and GLE450 vehicles. A 12-Volt ground connection under the driver seat may not be secured properly, resulting in the ground connection overheating.
An overheated ground connection can increase the risk of a fire.
Dealers will inspect and secure the 12-Volt ground connection as necessary, free of charge. Owner notification letters were mailed January 26, 2024. Owners may contact MBUSA customer service at 1-800-367-6372.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2021-2022 GLE350 and GLE450 vehicles. A 12-Volt ground connection under the driver seat may not be secured properly, resulting in the ground connection overheating.
An overheated ground connection can increase the risk of a fire.
Dealers will inspect and secure the 12-Volt ground connection as necessary, free of charge. Owner notification letters were mailed January 26, 2024. Owners may contact MBUSA customer service at 1-800-367-6372.
Certain vehicles equipped with 351 and 400 cleveland engines. Certain cleveland engines may experience fuel leakage at the rubber hose connecting the fuel inlet tube to the carburetor fuel filter. A fuel leakage in the engine compartment creates the potential for a fire.
No risk description available.
No remedy description available.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE BOLTS ATTACHING THE LOWER STEERING COLUMN TO THE INTERMEDIATE STEERING COUPLING CAN CONTACT THE BRAKE HYDRAULIC SYSTEM PIPES LOCATED IN THE ENGINE COMPARTMENT.
THIS CONDITION CAN LEAD TO A BRAKE HYDRAULIC FLUID LEAK AND REDUCED BRAKING PERFORMANCE.
DEALERS WILL REPOSITION THE PIPES TO PREVENT CONTACT BETWEEN THE PIPES AND BOLTS, AND ANY DAMAGED PIPES WILL BE REPLACED.
On certain Aztek (AWD), Montana (AWD), Relay (AWD), RendezVous (AWD), RendezVous (FWD), Silhouette (AWD), Terraza (AWD), Terraza (FWD), Uplander (AWD) and Venture (AWD) vehicles equipped with independent rear suspension, when operated in extreme cold temperature and on rough roads, water and salt can intrude past the ball joint seal. The combination of theses conditions may then lead to premature wear of the ball joint. If the ball joint wear progresses to the point of separation from the lower control arm, a loss of vehicle control may occur.
No risk description available.
Dealers will replace both ball joints with new ball joints which have a revised boot and ball stud to improve the seal to the ball stud shaft.
Porsche is recalling certain model year 2010 911 GT3 vehicles manufactured May 15, 2009, through February 11, 2010. The rear wheel hubs may be prone to failure under certain driving conditions. Also, the original, suggested maintenance intervals may be insufficient to prevent wheel hub failure.
If the rear hub fails, there may be a loss of vehicle control, increasing the risk of a crash.
Porsche will notify owners, and dealers will replace the wheel hubs on the rear axle free of charge. The service interval specifications will also be revised and provided to owners as part of Porsche's owner notification letter. The recall began on January 22, 2013. Owners may contact Porsche at 1-800-767-7243.
On certain vehicles, the check valve inside the fuel filler pipe may fall into the tank during refueling. This condition could cause fuel to spill out of the fuel filler pipe when the tank is being filled and refueling is stopped by the auto-stop system of the refuel gun. This may result in a fire if in the presence of an ignition source.
No risk description available.
Dealer will inspect the check valve. If the valve cannot be engaged or has fallen into the tank, the fuel tank will be replaced.
We may earn a commission for purchases made through these links.
