1,866 of 25,867 recalls from Transport Canada and NHTSA.
NOTE: VEHICLES EQUIPPED WITH 4.9 LITRE ENGINES. AN INCORRECT ENRICHMENT CALIBRATION TO THE FUELING STRATEGY OF THESE VEHICLES WHEN THE AIR CONDITIONER IS BEING USED MAY RESULT IN NON COMPLIANCE WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS.
No risk description available.
A NEW SERVICE PROM WILL BE INSTALLED WHICH WILL RESULT IN THE REDUCTION OF AIR POLLUTANTS WITHOUT REDUCING DRIVEABILITY.
On certain vehicles, the tire and loading information label lists a tire pressure for the spare tire. The label should instead read as ''NONE / AUCUN'', as the vehicles are not equipped with a spare tire.
While there is a low risk to safety, listing the correct information on the tire and loading information label is required by Canadian regulations.
None of the affected vehicles have been delivered to customers. Hyundai dealers will replace the tire and loading information label before the vehicles are delivered.
General Motors LLC (GM) is recalling certain 2020 Chevrolet Corvette vehicles. The release button located inside the front trunk compartment may not function after the vehicle has been shut off for ten minutes. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 401, "Internal Trunk Release."
If a person climbs inside the front trunk compartment and closes the lid, they may be trapped inside, increasing the risk of injury.
GM will notify owners, and dealers will update the software in the vehicle's Body Control Module (BCM) to allow the release switch to always work, free of charge. Owners also may allow the vehicle to be remedied via an Over-The-Air (OTA) software update. The recall began September 3, 2020. Owners may contact GM customer service at 1-866-522-9559. GM's number for this recall is N202309350.
Certain vehicles do not comply with the requirements of CMVSS 108. The airbag warning label is missing from the sun visors.
No risk description available.
Owners will be provided with labels and installation instructions.
On certain X5 M vehicles, the front side marker lamps are not illuminated as required by the Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. These vehicles were equipped with front side marker lamps, but not with the power supply cables leading to the lamps. As a result, the front side marker lamps do not illuminate. Reduced visibility increases the risk of crash causing property damage, personal injury or death.
No risk description available.
Dealers will install power supply cables for the front side marker lamps.
Certain vehicles were equipped with an incorrect SAM (Signal Acquisition and Activation Module) electronic control unit that does not cause the front side marker lights to illuminate as soon as the master lighting switch is moved to the headlamps "ON" position.
No risk description available.
Headlamp function will be checked and, the incorrect SAM unit will be replaced.
Certain vehicles fail to conform to Canada Motor Vehicle Safety Standard 208 - Occupant Restraint Systems in Frontal Impact. An incorrect electrical connection at the driver seatbelt buckle may not allow visual or audible warning if the vehicle is operated by an unbelted driver. Failure to remind the driver to buckle-up would increase the risk of personal injuries during a crash.
No risk description available.
Dealers will replace the driver seatbelt buckle electrical connector terminals.
Hyundai Motor America (Hyundai) is recalling certain 2025 Hyundai IONIQ 5 vehicles. The right-side headlight may have an incorrect headlight aim label, which can result in improperly aimed headlights. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment."
Improperly aimed headlights can result in insufficient illumination of the road, decreasing the driver's visibility and increasing the risk of a crash.
Hyundai will mail owners a corrected label with inspection and installation instructions. Owners may bring their vehicle to a dealer for the repair, free of charge. Owner notification letters were mailed July 15, 2025. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 279.
Kia America, Inc. (Kia) is recalling certain 2023 Sorento vehicles. The air bag warning labels on the driver and front passenger sun visors may detach. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."
A detached air bag warning label will not warn occupants about the risks of air bag deployment, increasing the risk of injury in a crash.
Dealers will inspect and replace the driver and front passenger sun visors, as necessary, free of charge. Owner notification letters were mailed October 10, 2023. Owners may contact Kia customer service at 1-800-333-4542. Kia's number for this recall is SC277.
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S. 1103 - EXHAUST EMISSIONS.
No risk description available.
No remedy description available.
Certain vehicles may fail to comply with the requirements of CMVSS 108 - Lighting System and Retroreflective Devices. The back-up lights within the tail light assemblies do not meet the photometric requirements of the standard.
No risk description available.
Dealers will replace the inner tail light assemblies.
On certain vehicles, the tire inflation pressure indicated on the vehicle certification label is not correct. Each of the labels includes tire inflation pressure information in kilopascals (KPA) and in pounds per square inch (PSI) for one of the three sizes of tires available on MPV's. In every case, the maximum tire inflation pressure specified in PSI is incorrect while the information provided in KPA is correct. The labels show the maximum tire pressure as 240 KPA / 32 PSI when it should be shown as 240 KPA / 35 PSI.
No risk description available.
Owners will be notified of the non-compliance by mail and will be provided with a corrected label that they can apply to their vehicle.
On certain vehicles, the outside of the driver's sun visor does not have the required airbag warning label. Canadian regulations require that information about the airbag system is provided on both sides of the sun visor.
This label provides a driver with information about the airbags and/or child restraint safety recommendations. Not following these recommendations could create an increased risk of injury.
Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealer to replace the driver's sun visor.
Certain vehicles do not comply with the requirements of CMVSS 114. The steering wheel does not lock when the key is removed from the ignition switch using the optionally provided override device that permits key removal in the event of electrical system failure or when the transmission is not in the PARK position.
No risk description available.
Since this does not pose any safety risk, no corrective action is required.
On certain Hypermotard 950 SP models, the side stand may break. If this happens, the motorcycle could fall over while it is parked.
A motorcycle that falls over could create a risk of injury to nearby people.
Ducati will notify owners by mail and instruct you to take your motorcycle to a dealer to replace the side stand.
General Motors LLC (GM) is recalling certain 2016-2017 Buick Envision vehicles manufactured February 4, 2016, to April 25, 2016. The Tire and Loading Information label may display the incorrect maximum weight information. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."
Incorrect weight information may cause an owner to overload the vehicle. Overloading may reduce vehicle control, increasing the risk of a crash.
GM will notify owners, and dealers will install a corrected label as necessary, free of charge. The began on August 22, 2016. Owners may contact Buick customer service at 1-800-521-7300. GM's number for this recall is 56340.
Mercedes-Benz USA, LLC (Mercedes Benz) is recalling certain model year 2013 GLK350 and GLK350 4-Matic vehicles, manufactured from May 31, 2012, through August 2, 2012, for failing to conform to the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 108, "Lamps, Reflective Devices, and Associated Equipment." The affected vehicles have voltage in the parking lamp circuit that exceeds the maximum value listed.
The higher illumination level may cause glare to oncoming vehicles, increasing the risk of a crash.
Mercedes Benz will notify owners, and dealers will update the software calibration number (SCN) of the subject electronic control unit. The recall began in September 2014. Owners may contact Mercedes Benz at 1-800-367-6372.
CERTAIN MINI VANS FAIL TO COMPLY TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS." AN INCORRECT GROSS AXLE WEIGHT RATING (GAWR) WAS INDICATED ON THE CERTIFICATION LABEL.
No risk description available.
OWNERS WILL BE MAILED ACCURATE CERTIFICATION LABELS AND INSERTS FOR THE OWNER'S MANUAL. OWNER NOTIFICATION BEGAN JUNE 12, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MAZDA AT 1-800-222-5500.
Certain motorcycles fail to conform to the requirements of Canada Motor Vehicle Safety Standard 120 – Tire Selection and Rims. Due to a typographical error, the size of the front tire, as indicated on the compliance label, is incorrectly identified as 130/70-18M/C63V instead of 130/70R18M/C63V.
No risk description available.
Dealers will replace the compliance label.
Certain vehicles do not comply with CMVSS 205 - Glazing materials. The windshields on these vehicles were produced without the "ASI" mark as required by American Standards Institute (ANSI) Z26.1. These windshields fully meet all of the requirements of standard 205.
No risk description available.
Since the absence of the "ASI" mark is highly unlikely to produce any risk of injury, no corrective action will be taken.
We may earn a commission for purchases made through these links.
