Jaguar Land Rover North America LLC (Land Rover) is recalling certain 2026 Land Rover Range Rover Velar, Range Rover Sport, and Range Rover vehicles. The seat belt warning system may not activate the audible warning chime as intended. As such, these vehicles fail to conform with the requirements of Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."
Safety Risk
A seat belt chime that fails to alert occupants that they are unbuckled can increase the risk of injury during a crash.
Remedy
Dealers will replace the audio amplifier, free of charge. Interim letters, notifying owners of the safety risk, are expected to be mailed July 10, 2026. Additional letters will be mailed once the remedy is available. Owners may contact Land Rover's customer service at 800-637-6837. Land Rover's number for this recall is D105.
76 vehicles affectedMfr ref: D105Updated June 10, 2026
Certain vehicles equipped with a Continuously Variable Transmission (CVT) fail to comply with CMVSS 101. The odometer and trip record counter are calibrated in miles rather than kilometres.
Safety Risk
No risk description available.
Remedy
Dealers will reprogram the odometer to record the distance traveled in kilometres. Where such reprogramming is not feasible or practical, the odometer will be replaced with one recording in kilometres.
TOYOTA IS RECALLING CERTAIN MODEL YEAR 2010 COROLLA VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION." THE AIR BAG LABEL INSTALLED ON THE DRIVER SIDE SUN VISOR CAN SEPARATE FROM THE SURFACE OF THE VISOR.
Safety Risk
THIS DOES NOT MEET THE STANDARD REQUIREMENTS.
Remedy
DEALERS WILL INSPECT THE LABEL AND EXCHANGE THE DRIVER'S SIDE SUN VISOR FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 3, 2009. OWNERS MAY CONTACT TOYOTA AT 1-800-331-4331.
CERTAIN SEDANS AND COUPES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES." CERTAIN REAR SEAT BELT BUCKLES WERE IMPROPERLY MANUFACTURED.
Safety Risk
THE REAR SEAT BELTS WILL WORK PROPERLY AND PROVIDE PROTECTION IN A CRASH, BUT THE OWNER MAY EXPERIENCE DIFFICULTY UNFASTENING THE BELT AFTER THE CRASH.
Remedy
IN A PREVIOUS RECALL (01V-380), ONLY RIGHT AND LEFT BUCKLES WERE INSPECTED. THE REAR CENTER BUCKLE SHOULD ALSO BE INSPECTED AND CORRECTED IF NECESSARY. THIS RECALL IS BEING CONDUCTED ONLY FOR THE CENTER BUCKLE. DEALERS WILL INSPECT THE VEHICLES AND REPLACE THE SEAT BELT ASSEMBLIES THAT WERE IMRPOPERLY MANUFACTURED. ONLY BUCKLES THAT ARE MARKED (ON THE BACK SIDE OF THE BUCKLE) WITH AN ASSEMBLY NUMBER BEGINNING WITH 00185, 00186, OR 00187, WILL BE REPLACED. OWNERS SHOULD CONTACT THEIR DEALER FOR THIS REPLACEMENT. OWNER NOTIFICATION BEGAN MARCH 5, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT HONDA AT 1-800-999-1009.
Certain vehicles may have incorrect payload information on the vehicle certification label. The payload shown on the label is greater than the maximum validated payload. If the vehicle is loaded to the incorrectly labeled payload, it may not ride and handle in the manner expected by the operator and could lead to loss of vehicle control and and/or an inability to stop the vehicle within expected stopping distances.
Safety Risk
No risk description available.
Remedy
Dealers will install a new label, directing operators to their owner's manual for payload information.
10,752 vehicles affectedMfr ref: 00063Updated June 10, 2026
Volkswagen Group of America, Inc. (Volkswagen) is recalling two 2018 Golf GTI vehicles. The VIN printed on the Federal Certification label may not match the actual VIN on the vehicle. As such, these vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification."
Safety Risk
If the stamped vehicle identification number (VIN) does not match the VIN on the Vehicle Certification Label, owners may be unable to tell if their vehicle is under an important safety recall, possibly exposing them to an increased risk of a crash, fire or injury.
Remedy
Volkswagen will notify owners, and dealers will install a correct certification label, free of charge. This recall began July 9, 2020. Owners may contact Volkswagen customer service at 1-800-893-5298. Volkswagen's number for this recall is 01E7.
2 vehicles affectedMfr ref: 01E7Updated June 10, 2026
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2012-2020 Volkswagen Passat and 2018-2019 Atlas vehicles. The blocking cap disabling the adjustment of the headlight's horizontal aim may not have been installed. As such, these vehicles fail to conform to Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
Safety Risk
Without the blocking cap, the headlight aim can be adjusted out of specification, reducing visibility and increasing the risk of a crash.
Remedy
Volkswagen will notify owners, and dealers will inspect and, as necessary, block the headlight horizontal adjustment, free of charge. The recall began July 16, 2019. Owners may contact Volkswagen customer service at 1-800-253-2834. Volkswagen's number for this recall is 94L9.
662,185 vehicles affectedMfr ref: 94L9Updated June 10, 2026
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2012-2020 Volkswagen Passat and 2018-2019 Atlas vehicles. The blocking cap disabling the adjustment of the headlight's horizontal aim may not have been installed. As such, these vehicles fail to conform to Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
Safety Risk
Without the blocking cap, the headlight aim can be adjusted out of specification, reducing visibility and increasing the risk of a crash.
Remedy
Volkswagen will notify owners, and dealers will inspect and, as necessary, block the headlight horizontal adjustment, free of charge. The recall began July 16, 2019. Owners may contact Volkswagen customer service at 1-800-253-2834. Volkswagen's number for this recall is 94L9.
662,185 vehicles affectedMfr ref: 94L9Updated June 10, 2026
On certain vehicles, the compliance label does not list the vehicle type in French and lists incorrect measuring units for the gross axle weight ratings (GAWR). This could lead to overloading of the vehicle and cause poor handling or a tire failure. Additionally, the tire and loading information label may be printed in English only. Canadian regulations require this information to be listed on the labels in both English and French.
Safety Risk
Poor handling or a tire failure could cause a loss of control and increase the risk of a crash. Additionally, a label that is missing information in French could cause confusion.
Remedy
FCA will notify owners by mail and advise you to take your vehicle to a dealership to replace the compliance label. A French tire and loading information label will also be installed, if necessary.
5,053 vehicles affectedMfr ref: D4AUpdated June 10, 2026
TRUCKS WERE BUILT WITH SPEEDOMETERS CALIBRATED IN MILES PER HOUR RATHER THAN KILOMETERS PER HOUR AND ODOMETERS CALIBRATED IN MILES RATHER THAN KILOMETERS AS REQUIRED BY FEDERAL SAFETY STANDARD 101 - CONTROL LOCATION.
Safety Risk
No risk description available.
Remedy
No remedy description available.
1,528 vehicles affectedMfr ref: 8G10Updated June 10, 2026
On certain vehicles, the odometer may not display properly after reaching 21,472 km. This error could lead you not to know how far the vehicle has travelled. As a result, an owner could miss or delay important vehicle maintenance.
Note: Only the Wrangler 4xe model is affected by this recall.
Safety Risk
Missed or delayed vehicle maintenance could lead to a part failure and increase the risk of a crash.
Remedy
FCA Canada will notify owners by mail and instruct you to bring your vehicle to a dealer to inspect, and if necessary, update the instrument panel cluster software. If your vehicle has over 21,472 km, and the odometer does not display, the instrument panel cluster will be replaced.
734 vehicles affectedMfr ref: Y94Updated June 10, 2026
On certain vehicles, the compliance label may be missing information in French. The words and abbreviations listed on the label for "TIRES", "RIMS", "WITH", "FR" and "RR" and appear in English only, when they should be listed as "TIRES/PNEUS", "RIMS/JANTES", "WITH/AVEC", "FR/AVT" and "RR/ARR". Canadian regulations require this information to be listed on the label in both English and French.
Safety Risk
These small errors do not affect vehicle safety.
Remedy
This is not a recall. Mitsubishi has corrected the compliance label for all new vehicles.
On certain vehicles, air bubbles could appear in the lower-left area of the windshield glass. As a result, the vehicle identification number (VIN) may be difficult to see through the glass.
Safety Risk
This problem could cause confusion when trying to identify the vehicle using the VIN.
Remedy
Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the windshield.
241 vehicles affectedMfr ref: PMA38Updated June 10, 2026
Hyundai Motor America (Hyundai) is recalling certain 2015-2016 Elantra vehicles. The trunk latch may become damaged, preventing the opening of the trunk from the inside. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 401, "Internal Trunk Release."
Safety Risk
A person inside the trunk compartment may become trapped, increasing their risk of injury.
Remedy
Dealers will replace the trunk latch base sub-assembly, free of charge. Owner notification letters were mailed April 5, 2024. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 256.
186,588 vehicles affectedMfr ref: 256Updated June 10, 2026
THESE VEHICLES DO NOT COMPLY WITH C.M.V.S.S 115 - VEHICLE IDENTIFICATION NUMBER. THE FOURTH CHARACTERS OF THE V.I.N. PLATE WHICH IS AFFIXED TO THE INSTRUMENT PANEL ARE CODED "F" RATHER THAN "E". "E" IS THE APPROPRIATE CODE FOR THESE 7000 POUND GVWR VEHICLES. AS A CONSEQUENCE, THE NINTH CHARACTER (CHECK DIGIT) OF THE V.I.N. IS ALSO INCORRECT. ONLY THE V.I.N. PLATE IS IN ERROR. THE SAFETY CERTIFICATION LABELS AND OTHER DOCUMENTS ON WHICH THE VEHICLE'S V.I.N. IS LISTED DISPLAY THE CORRECT V.I.N.
Safety Risk
No risk description available.
Remedy
DEALERS WILL REPLACE THE INCORRECT V.I.N. PLATES.
9 vehicles affectedMfr ref: 97S71Updated June 10, 2026
EGR VALVE MOUNTING BOLT MAY BE IMPROPERLY TIGHTENED ALLOWING AIR TO BE SUCKED INTO THE EGR SYSTEM. THIS MAY CAUSE THE NITROGEN OXIDES LEVEL TO EXCEED C.M.V.S.S.1103-EXHAUST EMISSIONS.
Safety Risk
No risk description available.
Remedy
No remedy description available.
595 vehicles affectedMfr ref: 9904Updated June 10, 2026
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2023 Audi S3, RS3, and A3 vehicles. The Safety Certification label on the B-pillar is missing weight capacity information. As such, these vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification."
Safety Risk
Missing weight information may result in unintentional overloading of the vehicle, increasing the risk of a crash.
Remedy
Audi dealers will install an overlay label, free of charge. Owner notification letters were mailed February 27, 2023. Owners may contact Audi's customer service at 1-800-253-2834. Audi's number for this recall is 50ZZ.
297 vehicles affectedMfr ref: 50ZZUpdated June 10, 2026
