Transport CanadaHigh Risk
Defect
REAR SEAT BACK HINGE LATCH COULD FAIL.
Safety Risk
No risk description available.
Remedy
No remedy description available.
2,143 vehicles affectedUpdated June 10, 2026
25,854 recalls from Transport Canada and NHTSA.
REAR SEAT BACK HINGE LATCH COULD FAIL.
No risk description available.
No remedy description available.
On certain vehicles, the driver side floor mat anchors could break over time which could allow the floor mat to slide forward and potentially allowing the accelerator to become stuck in the wide open position. A fully depressed accelerator pedal may result in very high vehicle speeds and make it difficult to slow or stop the vehicle. This could result in a crash causing injury and/or damage to property.
No risk description available.
Dealers will replace the driver side floor mat and possibly the accelerator pedal cover.
DUCATI IS RECALLING CERTAIN MODEL YEAR 2010 MULTISTRADA 1200 S TOURING EDITION MOTORCYCLES. THE MOTORCYCLE'S CENTER STAND MOUNTING SCREWS MAY COME LOOSE DURING NORMAL OPERATION. THIS SITUATION COULD CAUSE THE CENTER STAND TO POSSIBLY BECOME DISPLACED FROM ITS INTENDED MOUNTING POSITION RESULTING IN DAMAGE TO THE MOTORCYCLE AND A POTENTIAL HAZARD TO THE RIDER.
ANY DISPLACEMENT OF THE CENTER STAND COULD ADVERSELY AFFECT THE DRIVER'S ABILITY TO CONTROL THE MOTORCYCLE INCREASING THE RISK OF A CRASH.
DEALER WILL REMOVE THE CENTER STAND SCREWS APPLY THREAD-LOCKING COMPOUND AND REINSTALL THE SCREWS TO THE SPECIFIED TORQUE. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 13, 2010. OWNERS MAY CONTACT DUCATI AT 1-800-231-6696.
ON CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH A SUPERCHARGER, UNDER CERTAIN CONDITIONS, SUCH AS FULL THROTTLE IN LOW GEAR WHEN THE ENGINE IS NOT FULLY WARMED UP AND AT COLD AMBIENT TEMPERATURE, THE AMOUNT OF INTAKE AIR FLOW THROUGH THE AIR FLOW METER MAY EXCEED THE MAXIMUM PRESET DIAGNOSIS LIMIT VALUE.
THIS WILL CAUSE THE ENGINE CONTROL SYSTEM TO GO INTO THE FAILSAFE MODE. UNDER THIS CONDITION, THE MALFUNCTION INDICATOR LAMP WILL ILLUMINATE AND ENGINE SPEED WILL NOT EXCEED 2400 RPM REGARDLESS OF THE THROTTLE POSITION, INCREASING THE RISK OF A CRASH.
DEALERS WILL REPROGRAM THE ELECTRONIC CONTROL MODULE. OWNER NOTIFICATION BEGAN JANUARY 15, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT NISSAN AT 1-800-647-7261.
On certain Hypermotard 950 SP models, the side stand may break. If this happens, the motorcycle could fall over while it is parked.
A motorcycle that falls over could create a risk of injury to nearby people.
Ducati will notify owners by mail and instruct you to take your motorcycle to a dealer to replace the side stand.
On certain motorcycles, the hex nut that secures the front drive belt wheel to the gearbox output shaft was torqued to a value less than specification during the vehicle assembly process. As a consequence, the nut could loosen during vehicle operation. If this happens, the belt wheel would itself loosen on the output shaft, resulting in damage to the internal splines of the wheel and to the external splines of the output shafts as the vehicle is operated. Over time, the splines could be damaged to the extent that the output shaft would no longer operate the drive belt, resulting in a loss of drive capability at the rear wheel.
No risk description available.
Dealer will secure the front drive belt wheel to the gearbox output shaft by utilizing a new set of components, including a redesigned front wheel pulley. Also the main-shaft splines will be inspected for proper dimension and replaced is it is out of specifications.
General Motors LLC (GM) is recalling certain 2016-2017 Buick Envision vehicles manufactured February 4, 2016, to April 25, 2016. The Tire and Loading Information label may display the incorrect maximum weight information. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 110, "Tire Selection and Rims."
Incorrect weight information may cause an owner to overload the vehicle. Overloading may reduce vehicle control, increasing the risk of a crash.
GM will notify owners, and dealers will install a corrected label as necessary, free of charge. The began on August 22, 2016. Owners may contact Buick customer service at 1-800-521-7300. GM's number for this recall is 56340.
Chrysler (FCA US, LLC) is recalling certain 2021 Dodge Durango, Jeep Grand Cherokee WK, 2022 Jeep Grand Cherokee, and 2021-2022 Jeep Grand Cherokee L vehicles equipped with 3.6L engines. The exhaust gas recirculation (EGR) valve may stick open, resulting in an unexpected loss of drive power.
An unexpected loss of drive power increases the risk of a crash.
Dealers will replace the EGR valve assembly, free of charge. Owner notification letters were mailed June 23, 2022. Owners may contact FCA US, LLC customer service at 1-800-853-1403. FCA US, LLC's number for this recall is Z31.
Chrysler (FCA US, LLC) is recalling certain 2021 Dodge Durango, Jeep Grand Cherokee WK, 2022 Jeep Grand Cherokee, and 2021-2022 Jeep Grand Cherokee L vehicles equipped with 3.6L engines. The exhaust gas recirculation (EGR) valve may stick open, resulting in an unexpected loss of drive power.
An unexpected loss of drive power increases the risk of a crash.
Dealers will replace the EGR valve assembly, free of charge. Owner notification letters were mailed June 23, 2022. Owners may contact FCA US, LLC customer service at 1-800-853-1403. FCA US, LLC's number for this recall is Z31.
Chrysler (FCA US, LLC) is recalling certain 2021 Dodge Durango, Jeep Grand Cherokee WK, 2022 Jeep Grand Cherokee, and 2021-2022 Jeep Grand Cherokee L vehicles equipped with 3.6L engines. The exhaust gas recirculation (EGR) valve may stick open, resulting in an unexpected loss of drive power.
An unexpected loss of drive power increases the risk of a crash.
Dealers will replace the EGR valve assembly, free of charge. Owner notification letters were mailed June 23, 2022. Owners may contact FCA US, LLC customer service at 1-800-853-1403. FCA US, LLC's number for this recall is Z31.
Mercedes-Benz USA, LLC. (MBUSA) is recalling a 2019 S450 vehicle. The A, B, and C pillar covers may have been improperly installed, possibly affecting the deployment of the side curtain air bags and allowing the covers to detach in the event of a crash.
If a side curtain air bag does not deploy as intended, or the pillar covers detach during a crash, there is an increased risk of injury.
MBUSA will notify the owner, and a dealer will inspect the pillar covers, reinstalling them as necessary, free of charge. The recall began September 13, 2019. Owners may contact MBUSA customer service at 1-800-367-6372. MBUSA's number for this recall is 2019080006.
Ford Motor Company (Ford) is recalling certain 2024 Mustang vehicles. The brake pedal assembly may have been manufactured incorrectly, which can result in a loose brake pedal.
A loose brake pedal can result in a loss of braking function, increasing the risk of a crash.
Owners are advised not to drive their vehicle until the repair has been performed. Dealers will replace the brake pedal and bracket assembly, free of charge. Owner notification letters were mailed December 21, 2023. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 23S61.
This recall is for raised air intakes installed on new vehicles or sold as a dealer accessory. On certain vehicles, the raised air intake may not have been attached properly. As a result, the raised air intake could loosen and detach while driving.
A raised air intake that detaches from the vehicle could create a road hazard for others and increase the risk of a crash.
Land Rover will notify owners in writing and advise you to take your vehicle to a dealership to secure the raised air intake.
On certain vehicles, the shoulder portion of the seatbelt for the middle row right side seat of the seven passenger model and center seat in the eight passenger model, may bind in the bezel trim piece. If the seatbelt binds in the bezel, there is a possibility that extra webbing may exist in the seatbelt which could result in an improperly fitted seatbelt on a passenger. In the event of a crash, this could result in an increased chance of injury for that occupant.
No risk description available.
Dealers will inspect and, if necessary, replace the seatbelt bezel.
On certain vehicles, the threshold for the power window auto-reverse function may be higher than the design specification. This could result in personal injury if a body part becomes trapped by the closing window.
No risk description available.
Dealers will replace both window switches.
On a small number of vehicles, a software problem could cause the emergency calling (eCall) system not to work properly when there's a crash or when the SOS button is pressed.
If the eCall system doesn't work in an emergency situation, there could be a delay in response from emergency services.
Mercedes-Benz will notify owners by mail and advise you to take your vehicle to a dealership to update the communication module software.
Long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the passenger-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Note: For the 2010 and 2013 models listed, this recall only affects vehicles that were imported into Canada, and were originally sold or ever registered in certain areas of the United States that experience high or moderate levels of heat and humidity.
If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury.
General Motors will notify owners by mail and instruct you to take your vehicle to a dealer to replace the passenger-front airbag. Note: The Canadian climate results in the propellant degrading slowly. This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected.
On certain vehicles, the galvanized-braided-steel tailgate support cables used to support the tailgate in the full open (horizontal) position can corrode over time and fracture when loads are applied to them. Tailgate support cable corrosion may not be visible because of the plastic sheathing covering the cable. If one cable fractured, the remaining cable may retain the tailgate in a horizontal position. If the remaining cable was weakened by corrosion, it could fracture within moments of the first cable fracture. If both cables fractured, the tailgate would suddenly drop approximately 10 degrees and strike the top surface of the rear bumper. If anyone is sitting or standing on the horizontal surface of the tailgate when both cables fracture, they could fall and be injured. On vehicles without a rear bumper, the tailgate may drop to a lower position.
No risk description available.
Dealers will replace the existing galvanized support cables with stainless steel support cables.
On certain 2500HD and 3500HD series pickup trucks, the passenger frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the passenger airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant.
No risk description available.
Dealers will replace airbag inflators.
On certain vehicles, the front lower control arm ball joints may fail due to a manufacturing process error. if this occurs, the knuckle could separate from the front lower control arm, which could affect vehicle handling and increase the risk of a crash causing injury and/or damage to property.
No risk description available.
Dealers will inspect and replace the lower control arm to knuckle bolt and nut as necessary.
We may earn a commission for purchases made through these links.
