In certain conditions, the connection between the between fuse and fuse mount for the blower motor could overheat.
Safety Risk
A fuse and wiring that overheats could create the risk of a fire.
Remedy
Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealership to replace and relocate the blower motor fuse and its wiring. To reduce the safety risk, Mercedes-Benz recommends that you should only operate the blower in manual mode, and not use either the highest or lowest temperature settings until the recall repairs have been completed.
6,574 vehicles affectedMfr ref: 8297010Updated June 10, 2026
FORD IS RECALLING 1,357 MY 2009 EXPEDITION AND NAVIGATOR VEHICLES FOR FAILING TO COMPLY WITH THE FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THE BRAKE STOP LAMP SWITCH MAY BE IMPROPERLY ADJUSTED. THIS MAY RESULT IN A DELAY IN BRAKE STOPLAMP ILLUMINATION WHEN THE BRAKE PEDAL IS DEPRESSED. IN SITUATIONS OF VERY MILD BRAKE APPLICATION, THE BRAKE STOPLAMPS MAY NOT ILLUMINATE.
Safety Risk
DELAY OR LOSS OF BRAKE STOPLAMP FUNCTION MAY INCREASE THE RISK OF A CRASH.
Remedy
DEALERS WILL ADJUST THE BRAKE STOPLAMP SWITCH FREE OF CHARGE. THE RECALL BEGAN ON JULY 6, 2009. OWNERS MAY CONTACT FORD MOTOR COMPANY CUSTOMER RELATIONSHIP CENTER AT 1-866-436-7332 OR WWW.OWNERCONNECTION.COM.
THE FRAME MOUNTED FUEL FILTER MAY CRACK AT THE FUEL INLET MOUNTING NUT AS A RESULT OF FLEXING AND ALLOW FUEL LEAKAGE. THIS COULD CREATE THE POTENTIAL FOR A VEHICLE FIRE.
Safety Risk
No risk description available.
Remedy
VEHICLES WILL BE INSPECTED FOR CORRECT FUEL FEED PIPE INSTALLATION AND A NEW INTERMEDIATE FUEL FEED PIPE ASSEMBLY AND FUEL FILTER ASSEMBLY WILL BE INSTALLED IF REQUIRED.
29 vehicles affectedMfr ref: 0A11/90009Updated June 10, 2026
On certain vehicles operated at low temperatures (-29c), condensed moisture in the crankcase could be drawn into the carburetor and freeze. This condition could result in secondary throttle valve shaft icing which may cause the accelerator to stick in the open throttle position.
VOLVO IS RECALLING CERTAIN MODEL YEAR 2012 S60, XC60, S80 AND XC70 VEHICLES MANUFACTURED FROM MAY 16, 2011, THROUGH OCTOBER 6, 2011. IN THESE VEHICLES, THE WIRE HARNESS UNDER THE FRONT SEATS MAY HAVE NOT BEEN ATTACHED PROPERLY TO THE SEAT FRAME. AS A RESULT, WHEN THE SEATS ARE MOVED TO ADJUST THE SEATING POSITION, THE WIRE HARNESS MAY GET PULLED, CAUSING IT TO DISCONNECT.
Safety Risk
IN THE EVENT OF CRASH, THE FRONT AND/OR SIDE IMPACT AIR BAGS MAY DEPLOY IMPROPERLY OR NOT AT ALL, INCREASING THE RISK OF INJURY. ALSO, THE LAP BELT PRETENSIONER MAY NOT DEPLOY.
Remedy
VOLVO WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT AND, IF NECESSARY, SECURE THE SEAT WIRE HARNESS. THIS SERVICE WILL BE PERFORMED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 12, 2012. OWNERS MAY CONTACT VOLVO CARS AT 1-800-458-1552.
32,552 vehicles affectedMfr ref: 250Updated June 10, 2026
PERIODS OF EXTREME COLD TEMPERATURES CAN CAUSE THE RUBBER PROTECTIVE DIRT SLEEVE ON THE THROTTLE CABLE TO STIFFEN AND PREVENT THE THROTTLE FROM RETURNING TO THE IDLE POSITION.
THIS IS AN EXTENSION AND FOLLOW-UP OF RECALL V77123.
1977-1978 BMW 320I STANDARD - 5420001 TO 5442768
1977-1978 BMW 320I AUTOMATIC - 5470001 TO 5478332
Safety Risk
No risk description available.
Remedy
No remedy description available.
2,162 vehicles affectedMfr ref: 78C-02Updated June 10, 2026
On certain vehicles equipped with the Active Curve System (ACS), the oil in the ACS’s reservoir could start foaming under certain dynamic driving situations in combination with an oil level below minimum. The oil foam could leak out of the oil reservoir through the vent holes in the sealing cap and spray onto hot surface components of the exhaust system. This could increase the risk of fire causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will inspect the ACS reservoir for proper oil level and replace the sealing cap with an updated part.
On certain motorcycles, the distributor connector cap of the main wire harness was improperly wired, causing one ground circuit to be apportioned an excessive load. If the connector overheats, the power to various circuits could be lost. As a result, a loss of critical lighting or engine power could occur without warning, which could cause a crash.
Safety Risk
No risk description available.
Remedy
Dealers will inspect the ground distribution connector and check for damage. If any damage is found, the dealer will install an improved main harness. If no damage is found, the dealer will install a reconfigured connector cap that will apportion the ground load correctly.
On certain vehicles, improper nickel plating of certain fuel pump internal components could contaminate the pump, potentially resulting in an inoperative fuel pump. This could result in a no-start condition, or an engine stall without warning and without the ability to restart the vehicle, which could increase the risk of a crash.
Safety Risk
No risk description available.
Remedy
Dealers will replace the fuel pump.
1,203 vehicles affectedMfr ref: 20V5 / 20W5Updated June 10, 2026
On certain vehicles, the owner's manual does not include specific information about the adjustment of the head restraints for the third-row seats. Canadian regulations require this information be included in the owner's manual.
Safety Risk
This error is unlikely to affect safety.
Remedy
This is not a recall. This notice is for information only. The company will provide owners with a supplementary owner's manual booklet with information about how to adjust the head restraints for the third-row seats. The company has made changes to ensure that all new owner's manuals contain this information.
164 vehicles affectedMfr ref: 5891103Updated June 10, 2026
On certain vehicles, the fuel gauge may indicate a greater quantity of fuel than what remains in the tank. As a result, if the tank were to become empty, engine stalling could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing injury and/or property damage.
On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island, and Newfoundland & Labrador), the steering column lower intermediate shaft can become severely corroded. This could cause the swing link joint to become stiff or seized. As a result, the upper intermediate shaft could collapse, allowing the steering column lower bearing to separate, causing a loss of steering capability. A loss of steering control could result in a crash causing property damage and/or personal injury.
Safety Risk
No risk description available.
Remedy
Dealers will replace the steering lower intermediate shaft. The upper intermediate shaft and steering column lower bearing will be inspected and, if necessary, repaired or replaced. If the steering column lower bearing has separated, a retainer clip will be installed.
16,260 vehicles affectedMfr ref: 13S08Updated June 10, 2026
BMW of North America, LLC (BMW) is recalling certain 2020-2021 X3 sDrive 30i, X3 xDrive 30i, X3M 40i, X3 xDrive 30e, X4 xDrive 30i, X4M 40i, 530i, 540i, 540i xDrive, M550i xDrive, M5, 550e, 550e xDrive, and 550e iPerformance vehicles. A small portion of the rearview image may be slightly obscured. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Safety Risk
If the driver relies on only the rearview camera image, the reduced rearview image view can increase the risk of a crash or injury.
Remedy
BMW will notify owners, and dealers will inspect and, if necessary, program the rearview camera with updated software. The recall began November 18, 2020. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain 2020-2021 X3 sDrive 30i, X3 xDrive 30i, X3M 40i, X3 xDrive 30e, X4 xDrive 30i, X4M 40i, 530i, 540i, 540i xDrive, M550i xDrive, M5, 550e, 550e xDrive, and 550e iPerformance vehicles. A small portion of the rearview image may be slightly obscured. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Safety Risk
If the driver relies on only the rearview camera image, the reduced rearview image view can increase the risk of a crash or injury.
Remedy
BMW will notify owners, and dealers will inspect and, if necessary, program the rearview camera with updated software. The recall began November 18, 2020. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain 2020-2021 X3 sDrive 30i, X3 xDrive 30i, X3M 40i, X3 xDrive 30e, X4 xDrive 30i, X4M 40i, 530i, 540i, 540i xDrive, M550i xDrive, M5, 550e, 550e xDrive, and 550e iPerformance vehicles. A small portion of the rearview image may be slightly obscured. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Safety Risk
If the driver relies on only the rearview camera image, the reduced rearview image view can increase the risk of a crash or injury.
Remedy
BMW will notify owners, and dealers will inspect and, if necessary, program the rearview camera with updated software. The recall began November 18, 2020. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain 2020-2021 X3 sDrive 30i, X3 xDrive 30i, X3M 40i, X3 xDrive 30e, X4 xDrive 30i, X4M 40i, 530i, 540i, 540i xDrive, M550i xDrive, M5, 550e, 550e xDrive, and 550e iPerformance vehicles. A small portion of the rearview image may be slightly obscured. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Safety Risk
If the driver relies on only the rearview camera image, the reduced rearview image view can increase the risk of a crash or injury.
Remedy
BMW will notify owners, and dealers will inspect and, if necessary, program the rearview camera with updated software. The recall began November 18, 2020. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain 2020-2021 X3 sDrive 30i, X3 xDrive 30i, X3M 40i, X3 xDrive 30e, X4 xDrive 30i, X4M 40i, 530i, 540i, 540i xDrive, M550i xDrive, M5, 550e, 550e xDrive, and 550e iPerformance vehicles. A small portion of the rearview image may be slightly obscured. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Safety Risk
If the driver relies on only the rearview camera image, the reduced rearview image view can increase the risk of a crash or injury.
Remedy
BMW will notify owners, and dealers will inspect and, if necessary, program the rearview camera with updated software. The recall began November 18, 2020. Owners may contact BMW customer service at 1-800-525-7417.
BMW of North America, LLC (BMW) is recalling certain 2020-2021 X3 sDrive 30i, X3 xDrive 30i, X3M 40i, X3 xDrive 30e, X4 xDrive 30i, X4M 40i, 530i, 540i, 540i xDrive, M550i xDrive, M5, 550e, 550e xDrive, and 550e iPerformance vehicles. A small portion of the rearview image may be slightly obscured. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Safety Risk
If the driver relies on only the rearview camera image, the reduced rearview image view can increase the risk of a crash or injury.
Remedy
BMW will notify owners, and dealers will inspect and, if necessary, program the rearview camera with updated software. The recall began November 18, 2020. Owners may contact BMW customer service at 1-800-525-7417.
