On certain motorcycles, it is possible for the coating to separate from the inside face of the steering damper housing. If this happens, the coating could partially clog the oil bores within the damper. Should this occur, the steering damper could become stiff, making it difficult to steer, and therefore could result in a vehicle crash causing personal injuries or death.
Safety Risk
No risk description available.
Remedy
Dealers will inspect and, if necessary, replace the steering damper.
THE NUTS USED TO ATTACH THE REAR ROAD WHEELS TO THE AXLE SHAFT MAY LOOSEN BECAUSE OF AN OUT-OF-TOLERANCE AXLE SHAFT WHICH WILL NOT PERMIT FULL SEATING OF THE BRAKE DRUM ONTO THE AXLE SHAFT. THIS COULD RESULT IN WHEEL SEPARATION AND LOSS OF VEHICLE CONTROL.
Safety Risk
No risk description available.
Remedy
REAR AXLE SHAFTS WILL BE INSPECTED AND REPLACED AS NECESSARY.
190 vehicles affectedMfr ref: 265TUpdated June 10, 2026
THE FUEL TANK MAY LEAK AT THE SEAL BETWEEN THE FUEL FILLER PIPE AND THE FUEL TANK. FUEL LEAKAGE, IN THE PRESENCE OF AN IGNITION SOURCE COULD POTENTIALLY RESULT IN A FIRE.
Safety Risk
No risk description available.
Remedy
A FUEL FILLER PIPE TO FUEL TANK SEAL, WHICH IS MADE FROM DIFFERENT MATERIAL, WILL BE INSTALLED ON AFFECTED VEHICLES.
3,952 vehicles affectedMfr ref: 95S12Updated June 10, 2026
Certain motorcycles equipped with heated grips may have an insufficient expansion gap when turned on. This could cause the right hand throttle grip to expand beyond the limits of the available gap and cause the throttle return spring to stop working properly. This would make it difficult to slow or stop the vehicle which would increase the risk of a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will install a spacer to provide a sufficient gap for the heated grip to expand when turned on.
179 vehicles affectedMfr ref: SB 546Updated June 10, 2026
General Motors LLC (GM) is recalling certain 2016 Buick Envision vehicles manufactured January 19, 2016, to March 18, 2016. The the master cylinder brake lines may crack and leak brake fluid.
Safety Risk
If there is a loss of brake fluid, braking performance may be reduced or lost, increasing the risk of a crash.
Remedy
GM will notify owners, and dealers will replace the master cylinder brake lines, free of charge. The recall began on January 18, 2016. Owners may contact Buick customer service at 1-800-521-7300. GM's number for this recall is 16169.
327 vehicles affectedMfr ref: 16169Updated June 10, 2026
THE ORIGINAL OIL FILTER CANS ON THESE VEHICLES MAY FATIGUE AND FRACTURE CAUSING AN INITIAL VAPORIZED OIL SPRAY AND SUBSEQUENT OIL LEAK. SUCH VAPORIZED OIL SPRAY CAN RESULT IN OIL VAPOUR IGNITION BY THE HOT EXHAUST SYSTEM AND SUBSEQUENT UNDERHOOD FIRE.
Safety Risk
No risk description available.
Remedy
VEHICLES WHICH HAVE NOT HAD THEIR FIRST SERVICE INSPECTION WILL HAVE THE OIL AND FILTER CHANGED.
On certain motorcycles, the position of the hose clamps on the fuel filler drain hose & fuel breather hose is incorrect and, as a result, the two hoses may get damaged. Fuel leakage, in the presence of an ignition source, could result in a fire.
Safety Risk
No risk description available.
Remedy
Dealers will replace the fuel filler drain and fuel breather hoses, and reposition the hose clamps.
21 vehicles affectedMfr ref: RCL-08-004Updated June 10, 2026
THE TRANSMISSION BRACKET END FITTING MAY SEPARATE FROM THE SHIFT CABLE CONDUIT. IF THIS WERE TO OCCUR, THE OPERATOR WOULD NOT BE ABLE TO SHIFT THE TRANSMISSION FROM ONE OF THE DRIVE GEAR POSITIONS INTO THE PARK POSITION EVEN THOUGH THE GEAR SHIFT SELECTOR WOULD INDICATE "PARK. THIS CONDITION COULD RESULT IN UNINTENDED VEHICLE MOVEMENT IF THE PARKING BRAKE IS NOT SET.
Safety Risk
No risk description available.
Remedy
A NEW TRANSMISSION SHIFT CONTROL CABLE WILL BE INSTALLED ON AFFECTED VEHICLES.
1,404 vehicles affectedMfr ref: 97S81Updated June 10, 2026
General Motors LLC (GM) is recalling certain model year 2004-2007 Cadillac CTS-V vehicles manufactured October 6, 2003, to March 15, 2007, and 2006-2007 Cadillac STS-V vehicles manufactured June 23, 2005, to March 15, 2007. In the affected vehicles, the electrical terminals of the fuel pump module may overheat resulting in the melting of the flange material.
Safety Risk
If the flange melts, a hole may be created allowing the fuel pump to leak fuel, causing the vehicle to stall, increasing the risk of a vehicle crash. Additionally, leaking fuel in the presence of an ignition source increases the risk of a fire.
Remedy
GM will notify owners, and dealers will replace the fuel module and fuel tank jumper harness, free of charge. GM sent out interim notices in late October. The recall began on March 12, 2015. Owners may contact Cadillac customer service at 1-800-458-8006. GM's number for this recall is 14405.
On certain vehicles, the wheel hub nuts, outer tie rod nuts, front lower ball joint nuts, upper control link nuts and/or axle bracket bolts may not have been tightened properly. As a result, the fasteners could loosen and detach. If this happens, there could be a loss of power to the wheels, a loss of control and/or parts could separate from the vehicle.
Note: This problem could cause unusual noises from the front of the vehicle when steering and/or driving over bumps.
Safety Risk
A loss of power to the wheels and/or a loss of control could increase the risk of a crash. Additionally, parts that separate from the vehicle could create a road hazard for others and increase the risk of a crash.
Remedy
To reduce the safety risk, Mazda advises you to visually inspect the alignment of the front wheels before driving until the recall repairs have been completed. Mazda will notify owners by mail and advise you to take your vehicle to a dealership to inspect and tighten or replace the fasteners, as necessary.
98 vehicles affectedMfr ref: 7925JUpdated June 10, 2026
A POSSIBLE MIS-ALIGNMENT OF THE STEERING SHAFT MAY CAUSE A STRESS FRACTURE WHICH COULD RESULT IN THE COLLAPSE OR BREAKAGE OF THE EXPANDED JOINT, RESULTING IN LOSS OF STEERING.
Safety Risk
No risk description available.
Remedy
THE STEERING SHAFT WILL BE INSPECTED FOR PROPER ALIGNMENT AND A UNIVERSAL JOINT INSTALLED IN FRONT OF THE STEERING COUPLER.
The Timken Company (Timken) is recalling certain aftermarket front wheel bearings, part number 510072, sold from January 22, 2015, to May 21, 2015, to be used as service parts on 2001-2012 Ford Escape, 2001-2011 Mazda Tribute, and 2005-2011 Mercury Mariner vehicles. The affected wheel bearings have incorrect dimensions of a 42mm bore, 76mm outer dimension, and 39mm width, instead of a 42mm bore, 78mm outer dimension and a 45mm width.
Safety Risk
Use of an incorrectly sized wheel bearing can adversely affect the braking and steering of the vehicle, increasing the risk of a crash.
Remedy
Timken has begun notifying distributors who will offer purchasers replacement wheel bearings, free of charge. The recall began on May 21, 2015. Owners may contact Timken customer service at 1-866-984-6536.
HD TRUCKS AND BUSES WITH DETROIT DIESEL ALLISON 8.2 LITRE ENGINES. RECALL CONDUCTED BY DETROIT DIESEL ALLISON. IF EXCESS DIESEL FUEL OR LUBRICATION OIL ACCUMULATES AND CAUSES CRANKCASE TO OVERFILL, EXCESS FLUID CAN BE INGESTED THROUGH THE CDR VALVE INTO THE INTAKE SYSTEM CAUSING ENGINE SPEED TO INCREASE WITHOUT THROTTLE CONTROL. ALSO, GOVERNOR LINKAGE LOCK MAY LOOSEN AND SEPARATE FROM LINKAGE RESULTING IN ENGINE RUN-ON AND LOSS OF THROTTLE CONTROL. WHEN LIMITED STOPPING DISTANCE IS AVAILABLE, EITHER OF THESE CONDITIONS COULD RESULT IN VEHICLE CRASH WITHOUT PRIOR WARNING.
On certain vehicles, the fuel supply line may have been manufactured incorrectly, which could allow a fuel leak to develop. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury.
Safety Risk
No risk description available.
Remedy
Dealers will replace the fuel supply line.
339 vehicles affectedMfr ref: HL20Updated June 10, 2026
VEHICLE DESCRIPTION: LIGHT DUTY TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH 4-WHEEL DRIVE. THE ELECTRIC SHIFT TRANSFER CASE MAY NOT FULLY ENGAGE INTO GEAR WHEN THE OPERATOR MOVES THE TRANSFER CASE SELECTOR SWITCH.
Safety Risk
THIS COULD CAUSE THE TRANSFER CASE TO END UP IN THE NEUTRAL POSITION UNEXPECTEDLY AND ALLOW THE VEHICLE TO ROLL AWAY IF THE PARKING BRAKE IS NOT APPLIED.
Remedy
DEALERS WILL REPROGRAM THE TRANSFER CASE CONTROL MODULE. OWNER NOTIFICATION BEGAN APRIL 9, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.
On certain vehicles with gasoline powered engines, the accelerator pedal could move laterally, allowing the accelerator pedal bracket to be hung up on the stopper bolt on the floor panel bracket. This would cause the accelerator pedal to remain in the open position, increasing the risk of a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will remove and replace the stopper bolt with a flanged plate that will be bolted to the floor bracket to prevent lateral movement of the accelerator pedal.
On vehicles equipped with a jackknife-type folding key, over time the key blade may not stay locked in the fully extended (open) position. If you drive the vehicle with the key in the partially folded position, you could bump the ignition key and turn the engine off. This can cause a sudden loss of engine power, power steering and power brakes. This could also cause the airbags not to deploy in a crash.
Note: This recall only affects vehicles that have an "S" trim level.
Safety Risk
Airbags that do not deploy in a crash could create an increased risk of injury. A loss of power brakes can cause a sudden increase in brake pedal force and lead to an increase in stopping distance. A loss of power steering assist can cause a sudden increase in steering effort. A sudden loss of engine power could also increase the risk of a crash.
Remedy
Nissan will notify owners by mail and advise you not to attach any accessories to the key fob, and to ensure that the key is fully extended before driving. As an interim repair, a dealer will install a fastener in the key slot to prevent the key from folding. Once replacement parts are available, you will need to return to a dealership to have a spacer inserted into the slot of the key fob that will stop if from collapsing.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS EQUIPPED WITH A500 AUTOMATIC TRANSMISSION. INADVERTENT PLACEMENT OF THE SHIFT LEVER IN REVERSE CAN OCCUR WHEN THE DRIVER BELIEVES THAT THE TRANSMISSION HAS BEEN PLACED IN PARK.
Safety Risk
THIS CAN CAUSE THE VEHICLE TO ROLL AWAY WITH THE ENGINE ON AFTER THE DRIVER HAS LEFT THE VEHICLE.
Remedy
DEALERS WILL REPLACE THE STEEL MANUAL VALVE IN THE TRANSMISSION WITH AN ALUMINUM VERSION.
ENGINE COMPARTMENT FUEL LINE HOSE CLAMPS TEND TO DEFORM WHEN BEING TIGHTENED ALLOWING FUEL SEEPAGE INTO THE EINGINE COMPARTMENT WITH POSSIBILITY OF FIRE.
HLS30-200001 TO 225319
GHLS30-000001 TO 007045
Daimler Vans USA, LLC (DVUSA) is recalling certain 2015 Mercedes-Benz Sprinter 2500 and 3500 vehicles. These vehicles were manufactured without a protective plate on the front of the gas tank and a foam ring at the filler neck. As such, these vehicles may not comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 301, "Fuel System Integrity."
Safety Risk
Without the protective plate and the foam ring installed, impacts may damage the tank resulting in a fuel leak that can increase the risk of a fire.
Remedy
DVUSA will notify owners, and dealers will replace the fuel tank, free of charge. The recall began on June 6, 2017. Owners may contact DVUSA customer service at 1-877-762-8267.
