12,515 of 25,926 recalls from Transport Canada and NHTSA.
THE HEATER CORE END CAP MAY FAIL DUE TO MATERIAL DETERIORATION. THIS WILL ALLOW DISCHARGE OF HOT ENGINE COOLANT AND STEAM IN THE VICINITY OF THE DRIVER'S RIGHT FOOT.
No risk description available.
HEATER CORE WILL BE REPLACED WITH ONE HAVING A DIFFERENT DESIGN WHICH WILL NOT BE SUBJECT TO STRENGTH DETERIORATION.
Honda is recalling certain model year 2013 Pilot 2WD and 4WD vehicles and certain model year 2013 Odyssey vehicles. During manufacturing of the engine piston, it is possible that the heat treatment process was not properly applied, resulting in the piston having an insufficient hardness level, making it more susceptible to premature wear.
A worn piston may suddenly fail, causing the engine to stall, increasing the risk of a crash.
Honda will notify owners, and dealers will replace the engine short block free of charge. The recall began on September 16, 2013. Owners may contact Honda at 1-800-999-1009. Honda's recall numbers are JB4 (Honda Odyssey) and JB5 (Honda Pilot).
THE SHORT SECTION OF HIGH PRESSURE FUEL HOSE BETWEEN THE FUEL RAIL AND THE FUEL PRESSURE REGULATOR, WHICH RUNS ALONGSIDE THE INTAKE MANIFOLD, MAY BE SUBJECT TO HARDENING. IN THE EVENT THAT THIS LINE DOES HARDEN, FUEL LEAKS COULD DEVELOP BETWEEN THE HOSE AND METAL PIPE FITTINGS. LEAKING FUEL COULD IGNITE ON THE HOT EXHAUST SYSTEM AND LEAD TO AN ENGINE COMPARTMENT FIRE.
No risk description available.
FUEL HOSE WILL BE REPLACED ON 924S, 944 AND 944 TURBO VEHICLES AND THE FUEL HOSE AND FUEL RAIL WILL BE REPLACED ON 944S VEHICLES.
On certain E-350 and E-450 cutaway vehicles with school bus prep packages and some Econoline E-350 vans, certain frame rail tank guard brackets may have been omitted during vehicle assembly. These brackets are intended to prevent frame edge to fuel tank contact during a vehicle crash. As these vehicles were not evaluated for compliance without the use of brackets, their performance during a vehicle crash is thereby unknown. Should the tank be damaged enough to cause a fuel leak a vehicle fire could ensue, which may result in personal injury or death.
No risk description available.
Dealers will inspect and, if missing, install the brackets.
Honda (American Honda Motor Co.) is recalling certain 2024 Honda NC750X motorcycles. Due to an improper manufacturing process, the inner structure of the front tire may loosen and unravel, which can result in a loss of vehicle handling and control. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 119, "New Pneumatic Tires - Other Than Passenger Cars."
A loss of vehicle handling and control increases the risk of a crash or injury.
Dealers will replace the front tire, free of charge. Owner notification letters were mailed August 4, 2025. Owners may contact Honda customer service at 1-866-784-1870. Honda's number for this recall is KS4.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2022 EQB 300 and EQB 350 vehicles. The welded spur gear within the front axle electric drivetrain may not have been welded properly. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 114, "Theft Protection."
An improperly welded spur gear can fail and result in a vehicle rollaway, increasing the risk of a crash.
Dealers will replace the front axle electric drivetrain, free of charge. Owner notification letters were mailed on August 9, 2024. Owners may contact MBUSA at 1-800-367-6372. MBUSA's number for this recall is 2024060007.
Mercedes-Benz USA, LLC (MBUSA) is recalling certain 2022 EQB 300 and EQB 350 vehicles. The welded spur gear within the front axle electric drivetrain may not have been welded properly. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 114, "Theft Protection."
An improperly welded spur gear can fail and result in a vehicle rollaway, increasing the risk of a crash.
Dealers will replace the front axle electric drivetrain, free of charge. Owner notification letters were mailed on August 9, 2024. Owners may contact MBUSA at 1-800-367-6372. MBUSA's number for this recall is 2024060007.
On certain vehicles, the front control module may have been manufactured incorrectly. This could cause the engine to stall while driving, or not to start, and/or cause the windshield wipers to become inoperative. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash.
No risk description available.
Dealers will inspect the front control module and replace it if necessary.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain 2017 Audi Q7 vehicles manufactured August 30, 2015, to May 8, 2016. Due to a software issue within the air bag control module, the frontal air bags may deploy with more force than required in certain crashes. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."
Air bags that deploy with excessive force may increase the risk of injury.
Volkswagen will notify owners, and dealers will update the air bag control module software, free of charge. The recall began September 2016. Owners may contact Audi customer service at 1-800-253-2834. Volkswagen's number for this recall is 69O3.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain model year 2013-2017 Audi Q5 and 2013-2017 Audi Q7 vehicles. These gasoline-powered vehicles have a fuel pump flange that may crack, allowing fuel to leak.
A fuel leak in the presence of an ignition source increases the risk of a fire.
Audi will notify owners, and dealers will replace the fuel pump flange if cracks are present. Flanges that do not have cracks will have a protective film applied. These repairs will be performed free of charge. The recall began July 3, 2017. Owners may contact Audi customer service at 1-800-253-2834. Volkswagen's number for this recall is 20Z8. Note: This recall is an expansion of recall 16V-660.
Volkswagen Group of America, Inc. (Volkswagen) is recalling certain model year 2013-2017 Audi Q5 and 2013-2017 Audi Q7 vehicles. These gasoline-powered vehicles have a fuel pump flange that may crack, allowing fuel to leak.
A fuel leak in the presence of an ignition source increases the risk of a fire.
Audi will notify owners, and dealers will replace the fuel pump flange if cracks are present. Flanges that do not have cracks will have a protective film applied. These repairs will be performed free of charge. The recall began July 3, 2017. Owners may contact Audi customer service at 1-800-253-2834. Volkswagen's number for this recall is 20Z8. Note: This recall is an expansion of recall 16V-660.
Certain motorcycles may stall when the throttle is returned to the idle position. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the rider's reactions, could increase the risk of a crash.
No risk description available.
Dealers will update the Electronic Control Module software.
Chrysler (FCA US LLC) is recalling certain 2018-2019 Jeep Wrangler vehicles. The front track bar brackets may be improperly welded, which can cause the bracket to separate from the frame, reducing steering capability.
An unexpected reduction in steering ability, can increase the risk of a crash.
Chrysler will notify owners, and dealers will inspect and repair the track bar bracket welds, as necessary, free of charge. The recall is expected to begin November 17, 2018. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is UA5.
On certain motorcycles, the cam chain tension adjuster may not provide consistent tension to the cam chain in the engine. This could lead to cam chain breakage and sudden engine failure. Sudden engine failure while riding could cause rear wheel lockup, disturbing the rider's ability to control the motorcycle, and could cause a crash without prior warning.
No risk description available.
A redesigned cam chain tension adjuster and cam chain guide will be installed on affected vehicles.
On certain motorcycles equipped with a black-coloured clutch master cylinder, the hydraulic clutch system may not be able to generate enough lift to disengage the clutch after being parked for an extended period of time. If this occurs, the driver could lose control of the motorcycle at start up if it is left in gear or when it is first shifted into gear, which would increase the risk of a crash causing injury and/or damage to property.
No risk description available.
Dealers will flush the clutch system and rebuild the clutch master cylinder.
On certain motorcycles, the rear carrier platform could break if a Kawasaki Genuine Accessory Luggage System is installed on the carrier and a passenger leans against it. The carrier platform and luggage system could become detached from the vehicle, creating the potential for a crash resulting in personal injury or death.
No risk description available.
Dealers will replace the rear carrier platform.
On certain vehicles, a short circuit could cause heat damage, including melting or charring of the wire harness for the fuel pump and sender assembly and associated wire harnesses. In some cases the short circuit could have the potential for a vehicle fire.
No risk description available.
A fused jumper harness will be installed in the fuel pump ground circuit at the fuel pump inertia shut-off switch.
Volvo Trucks North America (Volvo) is recalling certain 2017 Volvo VHD, VNL, and VNM trucks manufactured February 19, 2016, to June 21, 2016. The affected vehicles were built with front wheel hubs that cannot support the gross axle weight rating of the front axle.
Overloaded front wheel hubs can result in premature failure of the hubs, bearings, and the related components, which can cause the front hub assembly to separate from the front axle. Because of this, the driver may lose control of the vehicle or parts may be dropped on the road, increasing the risk of a crash.
Volvo will notify owners, and dealers will replace the hub assemblies, free of charge. The recall began on February 16, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1607.
Volvo Trucks North America (Volvo) is recalling certain 2017 Volvo VHD, VNL, and VNM trucks manufactured February 19, 2016, to June 21, 2016. The affected vehicles were built with front wheel hubs that cannot support the gross axle weight rating of the front axle.
Overloaded front wheel hubs can result in premature failure of the hubs, bearings, and the related components, which can cause the front hub assembly to separate from the front axle. Because of this, the driver may lose control of the vehicle or parts may be dropped on the road, increasing the risk of a crash.
Volvo will notify owners, and dealers will replace the hub assemblies, free of charge. The recall began on February 16, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1607.
Volvo Trucks North America (Volvo) is recalling certain 2017 Volvo VHD, VNL, and VNM trucks manufactured February 19, 2016, to June 21, 2016. The affected vehicles were built with front wheel hubs that cannot support the gross axle weight rating of the front axle.
Overloaded front wheel hubs can result in premature failure of the hubs, bearings, and the related components, which can cause the front hub assembly to separate from the front axle. Because of this, the driver may lose control of the vehicle or parts may be dropped on the road, increasing the risk of a crash.
Volvo will notify owners, and dealers will replace the hub assemblies, free of charge. The recall began on February 16, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1607.
We may earn a commission for purchases made through these links.
