This recall was replaced by Transport Canada Recall No. 2022-607.
On certain vehicles, the connector pins within the Hydraulic Electronic Control Unit (HECU) assembly can corrode due to improper sealing of the HECU's wire harness cover. If moisture and road salt reaches the HECU's circuit board, electrical short circuits may occur to the circuit board, which could increase the risk of an underhood fire causing injury and/or property damage.
Safety Risk
No risk description available.
Remedy
Dealers will inspect the connector pins of the HECU for corrosion. If no corrosion is identified, dealers will replace the connector cover with a new one. If corrosion is present, dealers will replace the HECU assembly and connector cover with a new one.
10,115 vehicles affectedMfr ref: RC107Updated June 10, 2026
On certain vehicles, the bolted connection between the front control arm and swivel bearing may not have received adequate tightening torque during vehicle assembly. As a result, this bolted connection could loosen and/or break, affecting vehicle stability and control.
THE CLEAR COAT ON THE ALUMINUM WHEELS MAY BE THICKER THAN DESIRED. WHEEL NUTS ON A WHEEL WITH EXCESSIVE CLEAR COATING MAY LOOSEN OVER TIME BECAUSE THE CLEAR COAT LAYER COMPRESSES UNDER LOAD. IF THE VEHICLE IS OPERATED WITH WHEEL NUTS THAT HAVE LOOSENED, THEN ONE OR MORE HUB BOLTS MAY BREAK, AND THE WHEEL MAY COME OFF THE VEHICLE.
Safety Risk
No risk description available.
Remedy
THE CLEAR COATING WILL BE REMOVED FROM THE BRAKE ROTOR MATING SURFACE ON THE BACK OF EACH WHEEL, AND FROM THE WHEEL NUT MATING SURFACES. WHEELS, HUB BOLTS AND NUTS WILL BE INSPECTED AND REPLACED IF NECESSARY.
THE FRICTION PAD COULD SEPARATE FROM THE BACKING PLATE AND DISLODGE FROM THE FRONT OR REAR BRAKE CALIPER ASSEMBLY. THIS CONDITION COULD OCCUR WITHOUT PRIOR WARNING AND CAUSE A REDUCTION IN STOPPING ABILITY.
Safety Risk
No risk description available.
Remedy
FRONT AND REAR BRAKE FRICTION PADS WILL BE REPLACED.
317 vehicles affectedMfr ref: 076Updated June 10, 2026
On certain motorcycles, the software of the Hydraulic Control Unit (HCU) which controls the Anti-Lock Braking System (ABS) may be incorrect. If a braking event were to trigger the ABS, the motorcycle may not brake as intended, which could increase the risk of a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will either reprogram the HCU with the correct software or replace it.
On certain vehicles, the gear shift module may not have been manufactured properly. As a result, the transmission gear selection indicator (PRND) displayed next to the shifter may not work.
Safety Risk
A transmission gear selection indicator that doesn't work could create confusion and increase the risk of a crash.
Remedy
Land Rover will notify owners by mail and advise you to take your vehicle to a dealership to replace the gear shift module.
37 vehicles affectedMfr ref: D054Updated June 10, 2026
On certain vehicles, paint may have been applied unevenly on the rear axles. In cases where the paint was too thick, the allotted drying time may have resulted in insufficient paint hardness. Should this occur on the surface that contacts the rear axle lower link bracket bolt head and/or nut, the nut may later loosen. If the nut should detach fully separation of the lower link from the rear axle could occur. This may result in loss of vehicle control and a possible crash.
Safety Risk
No risk description available.
Remedy
Dealers will remove the rear axle lower trailing link nuts and bolts and replace them with new self-lock nuts and bolts.
2,416 vehicles affectedMfr ref: 00027Updated June 10, 2026
On certain vehicles, the left rear wheel bearing hub locking bolts may not have been properly torqued during assembly. This could cause the bolts to loosen and break, which could allow the wheel assembly to move outwards from the axle housing. If this occurs, the vehicle could become more difficult to control and braking distances would increase which could result in a crash causing injury and/or damage to property.
Safety Risk
No risk description available.
Remedy
Dealers will inspect and tighten the rear left wheel bearing hub locking bolts as necessary.
THE FRONT SHOULDER BELT GUIDE LOOP ATTACHED TO THE UPPER REAR CORNER OF THE DOOR, MAY INTERFERE WITH GARNISH MOULDING ON SOME VEHICLES. IN THE EVENT OF A VEHICLE CRASH THE SHOULDER BELT WEBBING COULD BE CUT BY THE GUIDE INCREASING THE RISK OF OCCUPANT INJURY.
Safety Risk
No risk description available.
Remedy
A NEWLY DESIGNED GUIDE LOOP NUT AND SPACER WILL BE INSTALLED ON ALL INVOLVED VEHICLES.
109 vehicles affectedMfr ref: 8A18/88027Updated June 10, 2026
The rear brake push rod has insufficient contact area with the rear brake master cylinder piston. A high pressure rear brake pedal application such as an emergency stop might cause the brake rod to penetrate the master cylinder plastic piston thereby resulting in a loss of effctive rear brake.
Safety Risk
No risk description available.
Remedy
No remedy description available.
41 vehicles affectedMfr ref: 040Updated June 10, 2026
On certain vehicles, the cover for the driver's knee airbag may become loose over time. If this happens, the airbag could start to unfold. This could cause the knee airbag not to inflate properly in a crash.
Safety Risk
An airbag that does not deploy properly could increase the risk of injury.
Remedy
Land Rover will notify owners by mail and instruct you to take your vehicle to a dealer to replace the driver's knee airbag module.
66 vehicles affectedMfr ref: N566Updated June 10, 2026
On certain vehicles, the wiper arm securing nuts could have been insufficiently tightened during assembly. If the movement of the wipers is restricted by an external load, such as heavy snow on the windshield, the wiper arms could slip and one or both wipers could become inoperative. If this occurs, driver visibility could be reduced, which could increase the risk of a crash causing injury and/or property damage.
Safety Risk
No risk description available.
Remedy
Dealers will clean the mating surface of the wiper arm and motor shaft and install improved wiper arm nuts.
16,756 vehicles affectedMfr ref: SSC189Updated June 10, 2026
On certain vehicles, the power steering pressure hose may separate at one of the crimps, causing a fluid leak. Power steering fluid leakage in the presence of an ignition source can result in an under hood fire. Additionally, a steering fluid leak may lead to a loss of power steering assist, requiring increased steering effort at low speeds.
Safety Risk
No risk description available.
Remedy
Dealers will replace the power steering pressure hose.
833 vehicles affectedMfr ref: 06026BUpdated June 10, 2026
Certain medium duty trucks equipped with 11,000 lb. Rear axle have a condition where the rear axle anchor plate may fracture. Under certain rebound, braking, or cornering maneuvers, the rear axle would be free to move fore and aft and provide unexpected steering inputs to the vehicle. If this happens while the vehicle is moving, a crash could result.
Safety Risk
No risk description available.
Remedy
Dealers will install a new rear axle anchor plate and spacer.
24 vehicles affectedMfr ref: 02028Updated June 10, 2026
ON CERTAIN VEHICLES, THE LUG NUTS ON THESE VEHICLES MAY NOT CREATE SUFFICIENT CLAMP LOAD ALLOWING WHEEL MOVEMENT IN RELATION TO THE HUB/ROTOR MOUNTING SURFACE. THIS COULD RESULT IN LOOSENING OF THE LUG NUTS, STUD FATIGUE FAILURE, AND THE POTENTIAL FOR A WHEEL TO SEPARATE FROM THE VEHICLE.
Safety Risk
No risk description available.
Remedy
WHEEL STUDS WILL BE INSPECTED AND WHEEL LUG NUTS WILL BE REPLACED WITH REVISED VERSIONS.
141,580 vehicles affectedMfr ref: 98S14Updated June 10, 2026
Certain vehicles may have an incorrect compliance label that does not meet the requirements of the Motor Vehicle Safety Regulations. The vehicle’s compliance label was misprinted with an incorrect manufacturing date of "12/99".
Safety Risk
No risk description available.
Remedy
Dealers will replace the compliance label with a corrected one.
Certain vehicles fail to comply with the requirements of CMVSS 120. The Tire and Loading Information Label was printed with incorrect Gross Vehicle Weight Rating (GVWR) and Gross Axle Weight Rating (GAWR) data. The information printed on the affected labels is that for the Civic LX model, which weighs less than the Civic EX model. The incorrect labels indicate a GVWR of 1665 kg, front GAWR of 880 kg and rear GAWR of 785 kg. The labels should instead indicate a GVWR of 1695 kg, front GAWR of 895 kg and rear GAWR of 800 kg. Since this does not pose any safety risk, no corrective action is required.
Certain sport utility vehicles equipped with a brush guard fail to comply with the requirements of C.M.V.S.S. no. 301, "fuel system integrity." The onboard refueling vapor recovery control valve can become detached during a crash, allowing fuel leakage in the presence of an ignition source can result in a fire.
Safety Risk
No risk description available.
Remedy
Dealers will install either a skid plate or a reinforcement bracket
2,997 vehicles affectedMfr ref: A10Updated June 10, 2026
On certain motorcycles, a plastic fitting between the fuel injector and hose can warp or break. This may cause a fuel leak which, in the presence of an ignition source, could result in a fire causing property damage, personal injury or death.
Safety Risk
No risk description available.
Remedy
Dealers will inspect and, if necessary, replace the fuel injector hose assembly.
166 vehicles affectedMfr ref: RCL-09-003Updated June 10, 2026
Certain vehicles fail to comply with the requirements of CMVSS 108 - Lamps, Reflective Devices, and Associated Equipment. Shields inside the headlamps became loose during a vibration test. If this occurred while under way, oncoming driver's may notice additional glare.
Safety Risk
No risk description available.
Remedy
Dealers will install two new headlamp assemblies.
376 vehicles affectedMfr ref: 04100Updated June 10, 2026
